110kV变站电气部分设计.doc

摘 要 5~10年选择，并考虑远期10~20年发展，50MW的主变压器。：按可靠性、选择性、灵敏性和速动性的要求对继电保护和安全自动装置进行了选择。主变压器配置了瓦斯保护、纵差动保护，线路进行了距离保护，过负荷保护及过电流保护等保护，对以上保护方式进行整定计算及装置选型。Abstract The electric parts of 110 kV substations, including electrical preliminary design is a part and electrical second part design. Will the substation as a step-down transformer substations consideration, three voltage level, i.e. consumers 10kV /110 kV / 35kV . The design of electric is a part of the main connection lines include: according to economic reliable, flexible operation requirement and the choice of all the connection mode of voltage level in terms of technology and economy, compared the optimal selection flexible connection mode. This design three voltage grade single bus are chosen for piecewise wiring way. According to plan 5 ~ 10 years choice, and consider the forward 10 ~ 20 years development, chose two 50MW main transformer capacity for. According to the various points short-circuit point calculate short-circuit a stationary current and short circuit current impulse, electrical equipment, power distribution equipment selection and total plane design and lightning protection design. The second part of the electrical design to include: the reliability, selectivity, agility and quick sex to the requirement of relay protection and safety automatic devices were chosen. The main transformer longitudinal gas protection, configuration of the differential protection, line distance protection, overload protection and over-current protection. To the above protective method in setting calculation and device selection. 第一章 设计内容和要求 1.1 变电所性质 变电站类型：110kV变电工程 电压等级，110/35/10kV； 1.2 电力系统接线简图 图1.1电力系统接线简图 1.3环境条件 本次设计的变电所位于近郊区，所处地区地势平坦，年最高气温+40℃，年最低气温-20℃，年平均气温+15℃, 最热月平均最高温度+32℃。 1.4 负荷情况 表1-1负荷数据 电压等级 负荷名称 最大负荷（MW） cosφ 重要负荷 所占比例 （％） 线路长度（km） Tmax （h） 近 远 35 kV 机械厂 13 15 0.8 68 10 5000