塑料保温水杯注塑模设计-注射模说明书.docVIP

PAGE XXIII- -哈尔滨理工大学学士学位论文XX学校毕业设计说明书课题名称： 学生姓名 学 号 所在学院 专 业 班 级 指导教师 起讫时间：　 年　月　日～　 年　月　 日基于UG的饮水杯模具设计摘要当前饮水杯注塑成型工艺方法很多，为了进一步提高生产效率，节约生产成本，本文在现有的注塑成型工艺冷却方面做了进一步改进，选择在型芯上开设冷却水道，希望缩短冷却过程，从而提高生产效率。本文主要介绍了经过优化型芯冷却系统后的饮水杯注塑模设计、塑料成形工艺以及注塑的过程，也对注塑机也进行了一些简单的介绍。主要设计过程有：塑料制品的工艺分析，型腔数目的确定，型芯冷却系统的设计，注塑机的选择以及模具的结构设计。本文设计的是一模两腔三板式模具，由于饮水杯的特殊形状，无法直接脱模，需设置侧面分型机构，本套模具是通过斜导柱进行侧面分型，本文对模具的各部分零件进行了设计与计算。在完成了一系列计算和构想之后，利用UG6.0画出注件的三维图，并设计好浇注系统、开模方向，然后进行开模仿真，在确定无误之后，利用EMX7.0设计模架，在完成模架设计之后，利用装配方法把整套模具完成整体设计并导出总装配图和爆炸图。通过采用组合式型芯，并在型芯块上设计螺旋状冷却水道的冷却系统措施后，注塑过程中注件得到了良好的散热，提高了注件生产效率。在现有的工艺上做了改善之后，饮水杯的注塑过程大大缩短，既提高了生产效率，同时也节约了生产成本。关键词：饮水杯；注塑模；侧分型 Plastic cup mound design based on UGAbstractMany methods in plastic cuPP injection molding process is adopted. To improve the efficiency further, a new type mold was designed in this paper in which cooling water channel was caved in the core. The design of module was introduced in this paper, especially the cooling system of core. Moreover, the injection process and machine were discussed. The main design process are: process analysis of plastic products, to determine the number of cavity, core cooling system design, structure design and the selection of injection molding machine and mold. A mold with two cavities was adopted in this work. Due to the special shape of plastic cuPP, it is difficult to put the cuPP off the mold directly. Therefore a side parting mechanism was set up to divide by the side of the oblique guide pillar. All part of part in mold was designed and calculated. After the completion of a series of calculation and design, UG5.0 software was used to draw the 3D map pieces, and good design of gating system, the parting direction, then the simulation of mold opening. After the completion of mold design, assembly method was adapted to assemble the whole mold and generate assembly map and map exp