塑料电子表盖的塑料模具设计论文.docVIP

桂林电子科技大学毕业设计（论文）报告用纸 编号： 　毕业设计(论文)说明书 题 目： 塑料电子表盖的塑 料模具设计 学　　院： 机电工程学院 专 业： 机械电子工程 学生姓名： 学 号： 指导教师单位： 机电工程学院 姓 名： 职 称： 题目类型：?理论研究 ?实验研究 ?工程设计 ?工程技术研究 ?软件开发 2013年5月24日 摘 要 塑料是一种新型工程材料.发展速度迅速，塑料的加工和成型工艺也越来越得到重视，其中注射成型是最常用的塑料零件成型方法之一。塑料电子表盖是人们日常生活中常见的家庭用品，与人们生活密切相关，其外观要求很高，而且整体体积小，形状曲面要求过渡平稳，对注射成型模具和工艺的要求极高。本次设计主要分析了塑料电子表盖的塑件成型工艺的特点，详细介绍了塑料电子表盖的结构设计和模具设计的过程以及要点。重点介绍了塑料电子表盖的塑件结构的设计方法，分析和阐述了模具分型面的选择、模具型腔数目的确定、注射机的选择、模架的选择方法、排气系统、浇注系、温度调节系统等的设计过程。 关键词：塑料电子表盖；塑料注射模；模具结构；点浇口。 Abstract Plastic is a new kind of engineering material. With its rapid development，Plastic Processing and forming technique have been getting more and more important，and Plastic injection molding is one of the most applied methods for parts molding. The cock is one of the most common domestic appliances and was closely related to people’s basic life. It features side opening, screw thread, and curve hole. It’s high requirement of fair outside aspect, small sizes, and smooth transition between two curve planetary need the injection mold and die which was used to form it of high accuracy and technique. The injection technological characteristics of Electronic watch cover were analyzed, and the design of structure ofElectronic watch cover and the main points of mould are also introduced specifically. The most advanced technology of mold design is adopted. The design method of plastic structure is mainly introduced. The selection of sidewall thickness, the decision of the mould cavity number, the selection of injection machine, and the designing process of the parting plane, the exhaust system and feed system were stated. The design structure characteristics of Electronic watch cover are two times parting planes with pin gate style, and side core-drawing structure. Key words: Electronic watch cover；plastic injection mould；mould structure；mould structure ;pin ga