《网络系统设计跟工程建设》试卷(无密码跟答案)-050709.docVIP

PAGE PAGE 7 浙江大学2004–2005学年夏季学期 《网络系统设计与工程》课程期末考试试卷 开课学院：计算机学院 ，考试形式：闭，允许带___________入场 考试时间：_2005_年_7月_9_日,所需时间： 120 分钟 考生姓名： _____学号： 专业： ________ 题序 一 二 三 四 五 六 七 八 总 分 得分 评卷人 注意事项： 请把答案写在答题纸对应的题号内； 有关IP地址表达方式，如果没有特别的掩码标明，则均按标准地址分类表示。 Please select the best choice for following question (60 points) Which of the following would be used to connect a router to an Ethernet switch? A. straight-through RJ45 cable B. cross-over RJ45 cable C. RS232 cable D. a V.35 cable How do you connect to a router using HyperTerminal? A. Connect the Ethernet port of your host to the Ethernet interface of the router using a rolled cable. B. Connect the COM port of your host to the Ethernet port of your router using a straight-through cable. C. Connect the COM port of your host to the console port of the router using a crossover cable. D. Connect the COM port of your host to the console port of the router using a rolled cable. Which of following command is used to print routing table of a Quidway router? display ip route display ip path show ip route display current-config Which layer-2 device enables high-speed data exchange? A. Repeater B. Hub C. Switch D. Router Which of the following is a correct ping to a host? A. Routerping B. Router#ping 55 C. Routerping D. Router#ping 56 How many subnets and hosts can you get from the network /26? A. 4 networks with 64 hosts B. 2 networks with 62 hosts C. 254 networks with 254 hosts D. 1 network with 254 hosts Answer B. I bet you struggled with this one, although it isn’t difficult. But the answers will make you think. First, the 254-host answers are not even close, so you have a 50/50 chance between the four-network and two-network options. The part you probably thought about the most is whether Cisco is using subnet-zero. This would provide four networks instead of two. Makes sense. However, Cisco does not consider subnet-zero valid on any of their exams. In addition, you cannot get 64 hosts with this mas