某城市-污水处理工艺设计.docVIP

PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT 3 某城市污水处理工艺设计 摘 要 本次设计的任务是处理污水处理的选择和结构设计和计算。该污水处理厂设计能力为8万吨/天使用该DE氧化沟工艺。该工艺具有工艺流程短，效果好，出水水质稳定，剩余污泥少，操作方便，管理，基础设施和运营成本低。本文介绍的过程中，结构和设计参数和工程预算的主要特点是，环境，经济分析，平面，高程布局，工艺图纸。该污水处理厂的污水流量从泵提升进入氧化沟流入格栅沉砂池的最后两个沉淀池污泥法处理污水从二次沉淀池排出的污泥首先进入污泥浓缩池，集中进一步脱水后的污泥外运。 整个工艺流程设计的车身结构，如格栅，竖流式沉砂池，氧化沟，触摸池系统的设计进行了详细的计算和解释。从理论上讲，这个过程中给出的BOD，COD，和氮的去除效率。在泥路中的增稠剂，脱水机的设计计算和解释。污水处理厂的布局和仰角的计算，使系统确定的各处理的结构和布局的高程。 关键词 氧化沟/工艺流程/污泥/工艺设计 ABSTRACT The task is to process sewage treatment choices and structures design and calculation. The sewage treatment plant design capacity of eighty thousand tons / day  DE oxidation ditch process using the card. The process has a short process, good effect, water quality and stability, less sludge, convenient operation and management, infrastructure and low operating costs. This paper introduces the process, the main characteristics of structures and design parameters and engineering budget, the environment, economic analysis, plane, elevation layout, process drawings. The sewage treatment plant sewage flow from the pump to enhance the inflow grille grit chamber into the oxidation ditch two final settling tank sludge process effluent from the secondary settling tank sludge discharged first into sludge thickener concentrate further dewatered sludge Sinotrans. The design of the entire process flow of the body structures, such as grille, vertical flow grit chamber, three oxidation ditch, touch pools for a detailed system design calculations and explanations. Theoretically this process gives the BOD, COD, and nitrogen removal efficiency. In the dirt road in the thickener, dewatering machine design calculations and explanations. The sewage treatment plant layout and elevation calculations, allowing the system to determine the elevation of each processing structures and layout. KEY WORDS Oxidation Ditch / Process / sludge / process design 第一章 设计任务及资料 1.1设计任务 选用一种生物处理工艺处理某城市污水 1.2 设计依据及背景 1.2.1 设计依据 《污水处理厂工艺设计手册》，给排水设计规范