软件基础及RSLinx入门课件.pptVIP

对于连砂石配比要严格控制好，监理工程师要随时抽查每层上土厚度（压实厚度不超过30CM）进行控制，超过规定厚度的必须要求其整改，并复测每一层标高。 软件基础及RSLinx入门 软件基础及RSLinx入门 主将：冯立 罗克韦尔自动化网络架构 Information Level Device Level Station MMI 24vdc 509 -BOD Modular I/O Block I/O Micro Drive Control Level Gateway or Linking Device Programmable Device Support PC Motor Starter Micro PLC Operator Interface Drive Servo Gateway or Linking Device Maintenance PC Desktop PC Controller “Old Way” = 源/目标方式 通常被主/从方式所采用 “The time is 8:00” “The time is 8:00” “The time is 8:00” “The time is 8:00” “The time is 8:00” “New Way” = 生产者/消费者方式 also referred to as “Publisher/Subscriber” contains all Source/Destination capabilities, plus additional capabilities for improved efficiency NetLinx的基本技术 设置 控制 数据采集 生产者/消费者服务方式 NetLinx网络的三大功能 Controller 控制器 Drive1 Sensor Drive3 Drive2 Data Acquisition HMI Analog I/O 传输效率非常低 - RIO, Profibus, Interbus S 传统控制方式-源/目标方式 Controller Drive1 Sensor Drive3 Drive2 Data Acquisition HMI Analog I/O Change-of-State 状态改变 - Sensor produces data only when object is present. Cyclic 周期性循环- Analog I/O can send one value (pressure) every 50 ms, and another value (temperature) every 500 ms Multicast 多点传送- simultaneous data consumption. 传输效率非常高 使用NetLinx技术的控制方式 如果支持通过网络进行设置，常常需要在主站中编程 否则就需要点对点的进行设置 Controller Drive1 Sensor Drive3 Drive2 Programmable Device Support HMI Analog I/O ( EN ) ( DN ) ( ERR ) MOV Dest: M1 Size: 32 words | / | N23:5/00 ( ) N22:1/06 ( ) O.0.1/10 | | I.0.2/04 ( EN ) ( DN ) ( ERR ) MOV Dest: M0 Size: 32 words 传统的设备配置方式 Very Efficient, devices communicate directly - not through bottlenecks 编程器直接通过网络进行编程 通过网络直接对设备进行组态 Controller Drive1 Sensor Drive3 Drive2 Programmable Device Support HMI Analog I/O ( EN ) ( DN ) ( ERR ) MOV Dest: M1 Size: 32 words | / | N23:5/00 ( ) N22:1/06 ( ) O.0.1/10 | | I.0.2/04 ( EN ) ( DN ) ( ERR ) MOV Dest: M0 Size: 32 words 使用NetLinx技术的设备配置方式 Controller Drive1 Sensor Drive3 Drive2 Data Acquisition HMI Analog I/O 主站通过轮询的方式采集数据 主站通过逻辑梯形图程序获取数据 数据需要被存储后进行转发 ( EN ) ( DN ) (