轴承寿命和轴向调节课件.pptVIP

对于连砂石配比要严格控制好，监理工程师要随时抽查每层上土厚度（压实厚度不超过30CM）进行控制，超过规定厚度的必须要求其整改，并复测每一层标高。 轴承寿命 预载荷 轴向游隙 过载 轻预载荷 轴向调节量 负载区在180o和360o之间 负载区等于360o 负载区等于180o 负载区小于180o 轴向游隙 径向游隙 零游隙（线到线接触） Bearing Life –vs.- Setting轴承寿命和轴向调节 Bearing Setting 轴承轴向调节 径向游隙 轴向游隙 Bench End Play (BEP)轴承轴向间隙 To establish BEP 建立轴向游隙 1.Calculate lateral loss due to tight fits 计算由于紧配合导致的横向损耗 2.Calculate lateral loss from thermal changes 计算热量变化导致的横向损耗 3.Choose BEP or BPL based on 12 基于第1和第2条来选择BEP或BPL 4.Calculate mounted end play range 计算装配后的轴向游隙范围 5.Calculate operating setting range 计算工作时的轴向调节范围 TRB Bench End Play 圆锥滚子轴承初始游隙 = Mounting setting Bench End Play or Radial Internal Clearance (C2, C0, C3…) = Operating setting - Temperature effect ________________________________ - Fitting effect ______________ Radial Internal Clearance 径向内部游隙 = 安装调整 初始游隙 或径向内部游隙 (C2, C0, C3…) = 运行时的调整 - 影响配合 ______________ - 温度影响 ________________________________ Bench End Play初始游隙 Establish Bench End Play 确定初始游隙 Chosen for desired performance 根据所需要的性能做选择 Operating Setting = BEP - - Lateral loss due to thermal changes Lateral loss due to fits 运行轴向 调节 = BEP - - 热量变化导致 的横向损耗 配合导致的 横向损耗 Shaft ID 2 Cone bore 1- ( ) 1- ( ) Lateral Loss due to Cone Fit由于内圈配合导致的横向损耗 Min. fit Max. fit X X = Shaft ID 2 Mean cone OD X K-factor 0.39 Cone bore Mean cone OD Min. LL Max. LL Cone Bore Mean Cone OD Shaft ID 最小配合 最大配合 K值 平均内圈外径 内圈内孔 轴内径 最小横向损耗 最大横向损耗 ( ) Mean cup ID 2 Housing OD ( ) Lateral Loss – Due to Cup Fit由于外圈配合导致的横向损耗 Housing OD Cup OD Mean Cup ID Min. fit Max. fit X X = Cup OD 2 Housing OD X Mean cup ID Cup OD K-factor 0.39 Min. L.L. Max. L.L. 1- 1- 平均外圈内径 外圈外径 轴承座外径 Lateral Loss due to Heat由