基于at89s51单片机的可控放大器设计lzdrloqx.docVIP

可控放大器偏向硬件的XXX 摘 要 本着简单、准确、可靠、稳定、通用的原则，采用了分级设计匹配互连的思想。系统的特色在于：通过开关，改变反馈电阻阻值，从而改变放大器增益，增益从10dB到60dB可调步距为10dB。 用单片机AT89s52对可控放大器进行程序控制，可以同时对两路输入信号进行二阶低通、高通、带通、带阻以及全通滤波处理，滤波器的中心频率在15kHz～50kHz频率范围内实现64级程控调节，其Q值在0.5～64范围实现128级程控调节。 作品通过实验完成，并制作成实物。设计采用压控增益器件AD603，进行合理的级联和阻抗匹配，加入后级功率输出，并能进行预置和控制，稳定性好，可控范围大。整个作品制作成本低、功耗小，除个别指标未能达到设计要求外，其它全部达到设计要求。 关键字：可控放大；AT89S52 ；程控增益 Controlled amplifiers hardware to Abstract In line with simple, accurate and reliable, stable and general principles, using a hierarchical design matching interconnection thoughts. System features: through switches, change the feedback resistance value, which changes amplifier, gain from 10dB to 60dB adjustable step distance for 10dB. With monolithic integrated circuit AT89s52 for controllable amplifier for program control, can to both road input signal second-order lowpass, qualcomm, band-pass, band-stop and total pass filtering processing, filter, the center frequency in 15kHz ~ 50kHz frequency ranges realize 64 level program-controlled adjustment, its Q value in 0.5 ~ 64 range realize 128 level program-controlled adjustment. Works through experiments completed, and made it into real. Design USES a voltage controlled gain device AD603 reasonable magnitude 7.3 impedance matching, join after class, and can output power preset and control, good stability and controllable range. The whole works made low cost, low consumption, in addition to the individual indexes failed to meet the design requirements, all other outside to meet the design requirements. Key word: controllable amplification, AT89S52 devices, Program-controlled gain 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc291972100 摘 要 PAGEREF _Toc291972100 \h 1 HYPERLINK \l _Toc291972101 目 录 PAGEREF _Toc291972101 \h 3 HYPERLINK \l _Toc291972102 第1章 可控放大器方案设计与论证 PAGEREF _Toc291972102 \h 4 HYPERLINK \l _Toc291972103 1.1 测量放大部分 PAGEREF _Toc291972103 \h 4 HYPERLINK \l _Toc291972104 1.2 滤波部分 PAGEREF _Toc291972104 \h 5 HYPERLINK \l _Toc291972105 1.