混泥土施工工艺关于自密实混凝土矿物掺合料胶凝系数取值的探讨.pdfVIP

学兔兔 2015年 第 11期(总第 313期 ) 混 凝 土 原材料及辅助物料 Number 11 in 2015(Total No．313) Concrete MATERIAL AND ADMINICLE doi：10．3969~．issn．1002—3550．2015．11．012 关于自密实混凝土矿物掺合料胶凝系数取值的探讨 狄秉臻，李福海，陈思银 (西南交通大学 土木工程学院，四川成都610031) 摘 要：依据JGJ／T 283—2012((自密实混凝土应用技术规程》进行大量配合比设计及和易性测试试验的结果，表明该规范在水 胶比计算式中给出的矿物掺合料胶凝系数取值不尽合理，建议应依据设计的自密实混凝土强度等级，相应的给出取值范围。试 验中依据此规范设计C40自密实混凝土配合比时，采用给定的胶凝系数，能设计出较为合适的水胶比，可达到较好的和易性效 果。而在设计C50自密实混凝土时，采用给定的胶凝系数，设计出的水胶比偏小，很难达到良好的拌和效果。通过对比JGJ 55— 2011《普通混凝土配合比设计规范》等规范，寻求设计较高强度自密实混凝土时，矿物掺合料胶凝系数合理的取值范围。 关键词：自密实混凝土；胶凝系数；配合比 中图分类号：TU528．041 文献标志码：A 文章编号：1002—3550(2015)11—0041—03 Discussion on the cementitious coefficient value of mineral admixtures of self—compacting concrete DIBingzhen，LI Fuhai，CHEN siyin (School of Civil Engineering，Southwest Jiaotong University，Chengdu 610031，China) Abstract：A large number of mix design and workability test according to“Technical specification for application of self—compacting concrete”JGJ／T 283-- 2012 show that cementitious coefficient value of mineral admixtures in the water—binder ratio formula iS not ver— Y reasonable．Their value range should be given based on self—compacting concrete strength grade．Based on this standard to design C40 self—compacting concrete，we can get a suitable water—binder ratio and achieve better workability using the given cementitious coeffi— cient in the experiment．But using the same method to design C50 self—compacting concrete，water—binder ratio is too small to get good effect．Through comparing with“Specification for mix proportion design of ordinary concrete”JGJ 55—_2011 and other standards． seeking reasonable cementitiou