焊接热循环计算机软件的研制和应用-JournalofNortheastern.PDF

第29 卷第2期 东 北 大 学 学 报 ( 自 然 科 学 版 ) Vol29, No. 2 2 00 8 年 2 月 Journal of Northeastern U ni ersity( Natural Science) Feb. 2 0 0 8 冯莹莹, 骆宗安, 张殿华, 王黎筠 ( , 110004) : , LabVIEW71 ; , , 7 , , 10 , , MMS- 200 : ; ; ; ; : T F 345 : A : 1005-3026( 2008) 02-0237-04 Development and Application of Computer Software for Welding Heat Cycle FEN G Ying-y ing , L UO Zong-an , ZH A N G D ian-h ua, WAN G L i-j un ( The State Key Laboratory of Rolling Automation, Northeastern Uni ersity, Shenyang 110004, China. Correspondent: FENG Y ing-ying, E-mail : fengyingy ing- 1982 @ 163. com) Abstract : The softw are for w elding heat cy cle w as de eloped successfully, based on some classical mathematic models and measured data and programmed appropriately by LabVIEW7. 1. It is a ailable to plot the cur e of w elding heat cy cle con eniently and quickly so as to reflect and describe quantitati ely the main influencing factors on the parameters of heat cycle and the correlation among them. This softw are comprises 7 kinds of w elding methods and each of them is based on its ow n mathematic model and applies to rele ant field. It can support 10 passes at most in the simulation of w elding heat cy cle, and the softw are interface is simple and easy to operate. By irtue of its stability, reliability and con enience, the softw are has been applied to MM S-200 thermal simulator. Key words: computer softw are; w elding heat cycle; w elding heat cy cle cur e; mathematic model; heat cycle parameters Gleeble