新型无锁相环DTATCOM直接电流控制方法.docVIP

第**卷 第***期 电测与仪表 Vol.** No.*** 2017年 第**期 Electrical Measurement Instrumentation ***.2017 PAGE \* MERGEFORMAT- 1 - 新型无锁相环DSTATCOM直接电流控制方法* 丁敏华1，姜干才1，徐胜光2，杨达亮2，吴宁2 杭州炬华科技有限公司，浙江 杭州 310030； 2．广西大学，电气工程学院，南宁 530004) 摘要：传统DSTATCOM直接电流控制方法依赖锁相环和坐标变换，实现较为复杂，本文提出一种新型无锁相环的DSTATCOM直接电流控制方法。通过建立DSTATCOM数学模型，依据矢量等效原理计算出配电网电压有功单位分量和无功单位分量，无需锁相环和坐标变换便可实现无功补偿控制。仿真验证了该方法的可行性。采用 DSP 控制器TMS320F2812和智能功率模块PM300DVA120，搭建了DSTATCOM系统实验平台，在开关频率10kHz、死区时间4μs下获得良好的实验结果。所提方法物理意义清晰且易于嵌入式控制器实现。实验结果表明，所提方法能实现输出电流超前滞后电压的无功补偿实时控制，具有良好的动静态响应性能。 关键词：配电网静止同步补偿器；锁相环；矢量控制；直接电流控制 中图分类号：TM933 文献标识码：B 文章编号：1001-1390（2017）24-0000-00 A novel direct current control method for DSTATCOM without PLL Ding Minhua1, Jiang Gancai1, Xu Shengguang2, Yang Daliang2, Wu Ning2 (1. Sunrise Technology Co., Ltd., Hangzhou 310030, Zhejiang, China. 2. College of Electrical Engineering, Guangxi University, Nanning 530004, China) Abstract：The Conventional conventional DSTATCOM direct current control method needs phase-locked loop (PLL) and the coordinate transformation, which making makes it difficult to implement. Therefore, A a novel direct current control method for DSTATCOM without PLL is proposed in this paper. By establishing the mathematical model of DSTATCOM, the active power unit component and reactive power unit component of the distribution network voltage are calculated based on the principle of vector equivalence, and the reactive power compensate control can be realized without PLL or coordinate transformation. Simulation Theresults verify the feasibility of novel control method is proved feasible by the MATLAB/Simulink . simulation results. The DSTATCOM system experimental platform is established using DSP TMS320F2812 controller and intelligent power module (IPM) PM300DVA120, the experimental results are excellent when the switching frequency is 10 kHz and the dead time is 4μs.T