PLC对极耳切割机的控制.docVIP

PAGE PLC对电池极耳切割机的控制 摘要：本文介绍PLC的形成与发展、组成、工作原理，PLC的指令系统以及PLC控制的优越性。伺服驱动器的组成、工作原理、基本性能参数以及通讯机能等内容。 本课题研究PLC对两台交流伺服驱动器的控制来驱动交流伺服电动机实现对电池极耳的切割。PLC对电池极耳切割的控制，是由PLC完成对两台交流伺服驱动器的控制，其中一台交流伺服驱动器(1)参数设定控制交流伺服电动机完成电池极耳长度的水平传动，另一台交流伺服驱动器(2)参数设定控制交流伺服电动机的电池极耳长度的切割。PLC的I/O点分配，PLC的I/O口控制电路的硬件设计，来完成对交流伺服驱动器的参数设定，从而驱动交流伺服电动机实现切割。PLC对电池极耳切割的设计为手动与自动，单次与连续。 电池极耳长度有三种规格，在操作箱上安装加减计数器，由工作人员输入规格长度。完成每一种规格长度的切割，依靠可调位置的激光传感器，对电池极耳上的胶物前沿定位确认，进行切割，误差小于1mm。机器每天工作10小时，完成两万个电池极耳的切割任务。每一种长度切割的数量由操作箱上安装的计数器来完成。PLC选用西门子晶体管输出NPN型。两台交流伺服驱动器均选用ASD-A0221LA型号，容量200W，交流单相220V输入。 关键词：可编程序控制器;交流伺服驱动器;交流伺服电动机 PLC control of the battery pole ear cutting machine Abstract: This paper introduces the formation and development of PLC, composition, working principle of the superiority of PLC instruction system and PLC control. Servo drives the basic composition, working principle, performance parameters and the communication function and so on. This topic research PLC control of the two ac servo drive and drive and exchange the servo motor to realize the battery pole ear cutting .PLC control of the battery pole ear cutting, are completed by PLC control of the two ac servo drives, including one (1) ac servo drives parameter setting control ac servo motor to drive complete battery pole ear length level, another ac servo drive control of ac servo motor (2) the parameters of the battery pole ear length cutting. I/O points of PLC, the PLC I/O port of the control circuit hardware design, to complete the setting parameters of ac servo drive, and drive and exchange the servo motor to realize cutting. PLC for battery pole ear design for manual and automatic cutting, single and continuous. There are three kinds of specifications, the battery pole ear length in operation box installed on the up-down counter, input specifications length by staff. Complete each kind of specification length cutting, rely on tunable laser sensor, the position of the battery pole ear rubber content on the front, one that for cutting, th