（毕业学术论文设计）-开槽筒形冲压件模具设计.docVIP

l 大 连 民 族 学 院 本 科 毕 业 设 计 论 文 开槽筒形冲压件模具设计 学 院（系）： 机电信息工程学院 专 业： 机械设计制造及其自动化 学 生 姓 名： 学 号： 指 导 教 师： 评 阅 教 师： 完 成 日 期： 大连民族学院 开槽筒形冲压件模具设计 PAGE \* MERGEFORMAT II 摘 要 本文研究的是开槽筒形冲压件的工艺分析和模具设计。模具是用来成型物品的工具，这种工具由各种零件构成。它主要通过成型材料物理状态的改变来实现物品外形的加工。本研究中零件的传统加工工艺是先经过落料，然后多次拉深，最后铣槽整形。工艺过程较为复杂，所获得零件的合格率差。本文中通过对给定开槽筒形零件的特征分析，推算出冲裁落料的零件形状，再根据拉深面积相等原则计算得到冲裁落料零件的尺寸公差。因此改进后，零件的加工工艺过程应该先落料然后经过拉深成型。针对落料和拉深过程，设计冲裁落料模和拉深模，其中冲裁模为导板导向。拉深模由于凸模尺寸小，设计了相应的结构以提高凸模刚度。改进后的工艺过程较为简单，环节少，有利于提高零件的质量。 关键词：开槽筒形件；模具设计；拉深；冲裁  Abstract The article is about the die design and process analysis of slotted cylindrical stamping. A mold is a tool which to make items forming. It is constituted by the various parts. It achieves the shape through the change of molding material in the physical state. In this study, the traditional processing technology of the part is to go through blanking, and then repeated stretching, the final milling to from shape. But the process is very complex, leading to the poor passing rate of the parts. In this article, through the analysis of the given slotted cylinders on the characteristics, it is able to design the shape of blanking part, and then baseing on the principle of equal area, the blanking parts’ tolerance can be calculated. Therefore, machining process will be blanking first and then after stretching to form the shape. For blanking and drawing process, blanking die and drawing die are designed. Board is the guiding device in the blanking die. In the drawing die, as the small size of the punch, the structure will be designed to improve the stiffness of punch. The process improved is relatively simple, with fewer links, it helps to enhance the quality of the parts. Key Words：slotted tube; die design; stretching; punching  目录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295492060 摘 要 PAGEREF _Toc295492060 \h I HYPERLINK \l _Toc295492061 Abstract PA