基于Proteus的LED时钟电路设计和仿真 毕业论文外文翻译.docx

Design and Simulation of LED Clock Circuit Based on Proteus Abstract：Based on the Proteus simulation software, the circuits of MCV controlling LED clock have been designed. The circuits include four parts: Hardware design, software programming, software simulation and physical display. Eventually, through the Proteus software simulation and physical display prove that the method of the circuit design is correct. This paper systematically introduces the design method of MCV controlling circuits and provides a complete design idea for the design of display circuit. Keywords：Proteus; LED; clock circuit I. INTRODUCTION Proteus is EDA software developed by the UK Labcenter Company, which can not only realize fundamental circuit simulation, but also simulate, debug MCU and peripheral circuits. With the Proteus powerful simulation capabilities and extensive resource libraries,the design process of hardware circuit can be effectively simplified. The Proteus simulation software can be firstly used in the design, simulation and debugging of the hardware circuit. When the results reach the demand, the physical circuits would been finally set up and debugged.This makes sure not only a high effective, low invested circuit design but also reduces the loss caused by burning of debugging in practice . In addition, it has also provided an effective design approach for hardware circuit design under scarce resource conditions in laboratory. II. HARDWARE DESIGN 80C52 is the control center of the whole hardware circuit. PO pins connect with six LED nixie tubes through two latches 74HC573 respectively. P2.6 and P2.7 in P2 pins of 80C52 respectively control the nixie tube segments elected and bit-selected signals. The Key connects with the P3.7 pin, which can clear the display . Six nixie tubes are divided into three groups from left to right,which presents respectively: hour (Hour_H, Hour_L),minute(Min_H, Min_L), second (Sec_H, Sec_L) ; PO pins connect with 74HC373 through external pull-