US3881ESE-AAA-000-RE;US3881EUA-AAA-000-RE;US1881ESE-AAA-000-RE;中文规格书，Datasheet资料.pdf

Section 3 - Applications 3 / Section 3 - Applications Introduction Solid-state switches have been available for many years. In various applications, Hall- Effect Sensors (Hall ICs) have replaced mechanical contact switches completely. In the mid 1980’s the ignition points in automobiles were replaced by Hall ICs. The automotive market now consumes more than 40 million Hall ICs per year. Melexis has been manufacturing high quality Hall-Effect Sensors and signal conditioning ASICs for nearly a decade, and has pioneered the next generation of programmable sensors and sensor interfaces. This section contains some fundamental information about Hall-Effect sensors, magnetics, and the added value of programmable sensors and sensor interfaces. It is intended to be useful for the novice as well as the expert. Design Kit Materials This section refers to magnets and devices which are included in the Melexis Hall-Effect Sensor Design Kit or the MLX90308 demo kit. Contents of these kits are listed below. These items can be ordered directly from the factory by contacting Melexis at (603) 223-2362. Hall-Effect Sensor Design Kit Square Neodymium, sample magnet “A” (approximately 200mT) Cylindrical Neodymium, sample magnet “B” (approximately 380mT) Gauss meter circuit diagram MLX90215 linear Hall Effect sensor and calibration chart Samples of various Melexis Hall ICs Sensor Interface Demo Kit ML