帘线钢82A精炼过程中氮含量的控制研究-中国科技论文在线.PDF

中国科技论文在线 帘线钢 82A 精炼过程中氮含量的控制研究# 代宁池，包燕平，王敏** （北京科技大学钢铁冶金新技术国家重点实验室，北京 100083 ） 5 摘要 ：研究的帘线钢冶炼流程为80tBOF →CAS →LF →VD →CC 工艺。通过对82A 级别帘线 钢精炼过程中各个工序氮含量取样分析，研究各工序增氮机制。结果表明，流程初始的CAS 工序氮含量可高达 59 ×10-6，增氮环节主要在出钢过程中合金的加入和吸入空气增氮。LF 精炼过程增氮 6 ×10-6~10 ×10-6；主要的降氮环节为VD 真空处理，降氮幅度在 20 ×10-6 左右。提出控氮等措施并进行工艺试验，铸坯中氮含量平均值控制在33.3 ×10-6，断丝率显 10 著下降并得到用户满意。 关键词：帘线钢；氮含量；精炼 中图分类号：TF769 Control of nitrogen content in 82A refining process of Tire 15 cord steel DAI ningchi, BAO yanping, Wang min (State Key Laboratory of Advanced Metallurgy，University of Science and Technology Beijing ， Beijing 100083) Abstract: IThe studied steelmaking flow sheet for tire cord steel is 80tBOF→CAS→LF→VD→CC 20 process. Through the sampling and analysis of nitrogen content in the process of refining ，the mechanism of nitrogen increasing in various processes is studied.Analysis results show that the nitrogen content in the initial process of CAS can be as high as 59 ×10-6 while the main source of the nitrogen increasing are the addition of the alloy and air inhalation. The increase of nitrogen content in LF refining process is 6×10-6~10×10-6 ；the main nitrogen reducing process is VD vacuum treatment 25 while the decrease range is about 20 ×10-6. The control of nitrogen and other measures are put forward. The average nitrogen content in the cast is controlled at 33.3 × 10-6 ，and the wire breaking rate decreases significantly. Key words: tir