二次受力叠合柱轴压下等效截面参数的研究-结构工程专业论文.docxVIP

Abstract At present, the reinforcement and reconstruction is being developed rapidly in China. Strengthening with reinforced concrete cover is an economical and efficient method that is being widely used. In the design of composite columns, the present code suggest the designers to simply superimpose the capacity of newly casted concrete to the old counterparts; and then a reduction factor is introduced to compromise the overall bearing capacity. In the seismic calculations, the traditional way is to consider the capacity of newly casted concrete as the old counterparts. However, this method may lead to error in stiffness estimation of reinforced components. Since the current structural design software cannot input appropriate composite column parameters, the thesis is aim at deducing the formula of equivalent cross-section parameters, which is of theoretical and engineering importance. The article focused on the section-enlargement Method which is widely used in practical engineering. Many important situations and factors are taken into consideration. They are the fact that the sustained load cannot be completely released, the strength ratio and area ratio of new concrete and old concrete. Deducing the theoretical solution of normal section bearing capacity, we obtain the simplified formula of composite column. To verify the validity of the formula, a numerical model is established using ANSYS based on the data from literature. Finally, the deduced formula is applied to a established model analysis. And by further analysis the internal force and reinforcement configuration, the case study verifies the applicability of the deduced formula. Based on the related theories and results of the experimental results, the finite element analysis and the case study, the Section-Enlargement Method is verified. The results show that: the equivalent cross-section method can factually reflect the behavior of the composite column. This method provide a practical basis for numeric