Al-Cu-Mg合金断裂韧性与拉伸延性模拟.PDFVIP

第 17 卷第 7 期 中国有色金属学报 2007 年 7 月 Vol.17 No.7 The Chinese Journal of Nonferrous Metals Jul. 2007 文章编号：1004-0609(2007)07-1034-07 Al-Cu-Mg 合金的断裂韧性与拉伸延性模拟 宋 旼 ，袁铁锤，张福勤，黄伯云，陈康华 ( 中南大学 粉末冶金国家重点实验室，长沙 410083) 摘 要：基于铝合金中的脆性结晶相在外力作用下发生断裂而形成微裂纹的过程服从 Weibull 分布，建立了 Al-Cu-Mg 合金断裂韧性与拉伸延性的细观力学模型。模型的解析表明，在外力作用下由结晶相断裂而形成的微 裂纹的体积分数随着外加应力的增加而增加；在相同的外加应力作用下，结晶相含量较高时微裂纹的体积分数也 较高。同时模型的计算表明，Al-Cu-Mg 合金的拉伸延性及断裂韧性与结晶相的含量及尺寸有很大关系；拉伸延 性与断裂韧性随着结晶相体积分数与尺寸的增加而减小；因此通过对铝基体的纯化，减少 Fe 与 Si 元素的含量或 者通过强化固溶处理可以降低结晶相的体积分数与尺寸，从而提高 Al-Cu-Mg 合金的拉伸延性与断裂韧性。 关键词：铝合金；拉伸延性；断裂韧性；Weibull 分布 中图分类号：TG 249.9 文献标识码：A Modeling on fracture toughness and tensile ductility of Al-Cu-Mg alloy SONG Min, YUAN Tie-chui, ZHANG Fu-qin, HUANG Bai-yun, CHEN Kang-hua (State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China) Abstract: A meso-scaled model was developed for the fracture toughness and tensile ductility of Al-Cu-Mg alloy based on the fact that the volume fraction of microcracks caused by the constituents cracking satisfies Weibull distribution under externally applied stress. Model analysis indicates that the volume fraction of microcracks caused by the constituents cracking increases with the externally applied stress. Under the same externally applied stress, the volume fraction of the microcracks increases with that of the constituents. The model calculation indicates that the fracture toughness and tensile ductility of Al-Cu-Mg alloy decrease as the size and volume fraction of the constituents increase. Thus,