某新建一级公路工程设计.docxVIP

摘要 为了巩固我们所学的知识，并在各方面得到更进一步的提高，我们选择了苏州至无锡某新建一级公路工程设计作为毕业设计，这是在毕业之前对自身学习状况的最后一次检查。 我所选择的设计路段是从K0+000至K3+651.654段，全长3651.654米，设计车速80km/h,路基宽度为24.5m。 此次毕业设计主要包括的内容如下： 1、路线设计：在已知平面图的情况下，进行纵断面的设计，要求线路顺畅、填挖平衡、经济合理。 路基设计：包括各个桩号的填挖计算、填挖较大地段的稳定分析、整个线路的土石调运借配等。 路基、路面排水工程；高填挖地段的防护工程以及路基加固工程：这一部分相当重要，对于路基排水，采用了边沟、截水沟、急流槽等排水设施；对于路面排水，除了对路面进行了路拱设计；对于特殊路段的防护和加固主要采用了骨架内植草和挡土墙。 路面设计：路基在不同干湿状态下，设计沥青路面要求经济合理，便于施工并满足各设计规范要求。 关键词　路线；路基路面；综合设计 Abstract In order to consolidate our knowledge, and in all respects to be further improved, we chose LiaoNing province a new highway design as part of the graduation design, it is before graduation of their learning situation for a final check. In this design, our task is to design an secondary road. The road, which is 3651.654 m from K0+000 to K3+651.654. The design speed is 80km/h and the wide of the subgrade is 24.5m. 1、Route design : the known ichnography, longitudinal section design, request line smooth, cut and fill balance, economic and reasonable. 2、The roadbed design: including various pile excavation calculation, cut and fill larger sections of the stability analysis, the whole line of earth-rock allocation by etc..The design of pavement, and this contents that the select of the construction about concrete and asphalt pavement in different case. 3、Subgrade, pavement drainage engineering; high cut and fill area protection works and foundation reinforcement engineering: this part is very important, for the drainage of subgrade, the ditches, drainage ditches, chute, drainage facilities; to pavement drainage, in addition to the pavement of road design; in the special section of the reinforcement and protection by the framework of grass and earth retaining wall. 4、avement design: Subgrade under different wet and dry conditions, design of asphalt pavement requirements reasonable economy, convenient construction and meet the design requirement.. Keywords　 way roadbed road surface bridge culvert 目录 TOC \o 1-3 \h \z \u HYP