《支撑架压铸模CAD设计及CAE成型仿真》-毕业论文.docVIP

PAGE 1 安徽建筑工业学院 毕 业 设 计 (论 文) 专 业 机械设计制造及其自动化 班 级 08机械一班 学生姓名 学 号 08210010113 课 题 支撑架压铸模三维CAD设计 及CAE成型仿真 指导教师 2012年 6 月 1 日 支撑架压铸模CAD设计及CAE成型仿真 中文摘要 首先，分析支撑架压铸件的结构工艺，提出几种不同的压铸工艺方案，计算环形浇口尺寸、弯销尺寸、充填速度、温度、压实压力等工艺参数，完成压铸模结构设计。然后，确定模具分型面和浇注系统，借助PRO/E三维软件，对支撑架零件三维造型，解决模具的结构设计。在此基础上，应用CAE软件PROCAST仿真支撑架充填、凝固过程，优化压铸模具结构设计。再次，绘制模具装配图、零件工程图，同时校核模具关键零件的强度。最终表明该模具结构合理，制造工艺良好，工作稳定可靠。 关键词：压铸模；环形浇口；弯销；分型面；Pro/E；CAE Support frame Die-Casting Mould CAD / CAE ABSTRACT In this thesis, firstly, the structures of the Support frame die-casting were analyzed. The structure of die casting die was designed through the analysis of various process planning and the calculations of technological parameters of ring gate, bent pin, speed, temperature, pressure, etc. Secondly, the mold parting surface and gating system must be determined. By using 3D PRO/E software, the die-casting model and the mould structure had been drawn. On the basis, the design of die-casting mould structure was optimized through the application of CAE software PROCAST simulating the pressure filling and solidification course. Then, the Mold assembly drawings, parts drawings were drawn and the key parts intensity was checked. Finally, the conclusions show that the mold structure is reasonable, stable, reliable and the mould has good manufacturing processes. Keywords: Die-casting mould；ring gate；bent pin；mould surface；Pro/E；CAE 目录 TOC \o 1-3 \h \u HYPERLINK \l _Toc326766726 第一章 前言 PAGEREF _Toc326766726 \h 1 HYPERLINK \l _Toc326766727 1.1 课题的提出 PAGEREF _Toc326766727 \h 1 HYPERLINK \l _Toc326766728 1.2 国内外压铸研究的现状 PAGEREF _Toc326766728 \h 1 HYPERLINK \l _Toc326766729 1.2.1国外压力铸造业的现状 PAGEREF _Toc326766729 \h 1 HYPERLINK \l _Toc326766730 1.2.2国内压力铸造业的现状 PAGEREF _Toc326766730 \h 1 HYPERLINK \l _Toc326766731 1.3设计的内容和目标 PAGEREF _Toc326766731 \h 2 HYPERLINK \l _Toc326766732 1.3.2．重点需要研究