《棱镜片在背光源下的应用研究》-毕业论文.doc

摘 要 平板显示中的液晶显示, 用途非常广泛, 使用量很大。而随着液晶显示器的大量应用, 其背光模组的组成元件也逐渐被人们所关注。尤其以棱镜片为最主要的技术和成本所在。 本文主要通过在背光模组中改变棱镜片结构，来研究棱镜片中央辉度增益效果与基材厚度、UV胶的折射率及棱峰走向的关系。最后总结出棱镜片基材厚度对其增益效果没有影响，为使棱镜片获得最好的增益效果应使棱峰走向与线光源平行、提高UV胶的折射率。但是提高UV胶的折射率必定会增大成本的投入，且有更高的技术要求。因此在生产应用中还需与实际要求相结合。 关键字：背光源、液晶显示器、棱镜片、UV胶 Abstract LCD flat panel display has a very wide range of great use. With the large use of LCD applications, the composition of the backlight module components have been of great concern to the people gradually. Particularly prism film is where the most important technology and cost. In this paper, the aim is to study the relationship among the brightness gain of the central prism film and the substrate thickness effect, UV glue to the refractive index and the peak edge by changing through the backlight prism sheet structure. At last, it draws a conclusion that the thickness of the prism sheet substrate does not affect their buffs. In order to make the prism film buffs have the best brightness gain, it should make the peak edge parallel to the direction and line source and try to improve the refractive index of UV glue. However, in order to improve the refractive index of UV glue ,it will certainly increase the cost of inputs and have higher technical requirements. Therefore, it needs to combine with the practical requirements in production applications. Key words: back light、Liquid crystal display、prism sheets、Ultra Voilet curing adhesive 目录 TOC \o 1-3 \h \u HYPERLINK \l _Toc17873 第一章 绪论 PAGEREF _Toc17873 1 HYPERLINK \l _Toc14664 1.1液晶产业的发展现状 PAGEREF _Toc14664 1 HYPERLINK \l _Toc23069 1.1.1 国外研究现状 PAGEREF _Toc23069 3 HYPERLINK \l _Toc21414 1.1.2 国内研究现状 PAGEREF _Toc21414 4 HYPERLINK \l _Toc10718 1.2 背光模组的简介 PAGEREF _Toc10718 5 HYPERLINK \l _Toc6632 1.2.1 背光模组的分类 PAGEREF _Toc6632 5 HYPERLINK \l _Toc41 1.2.2 背光模组的架构 PAGEREF _Toc41 6 HYPERLINK \l _Toc16124 1.3 棱镜片主要的工艺技术方法 PAGEREF _Toc16124 9 HYPERLINK \l _Toc12205 1.3.1棱镜片的工艺技术体系 PAGEREF _Toc12205 9 HYPERLINK \l _Toc4176