大型复杂薄壁结构件加工变形仿真与控制技术研究-航天工程专业论文.docx

大型 大型复杂薄壁结构件加工变形仿真与控制技术研究 北华 北华航天工业学院硕士学位论文 PAGE PAGE IV PAGE PAGE III Abstract Research on the thin walled parts can greatly increase the application performance of the product with the development of aerospace products. But this kind of parts with complex shape structure, external coordination requirements, the outline of the part with relatively large sectional dimension, the removal amount of processing materials ， the overall poor rigidity, the rebound for cutter and machining vibration phenomenon of work piece is very obvious during machining process. This is a direct result of processing quality is difficult to guarantee and the processing efficiency is very difficult to improve after the completion of the parts. This has greatly affected the competitiveness of the products and the economic benefit of enterprise. Therefore, it has important theoretical significance and engineering practical value to deformation simulation and control technology of thin wall parts. This study summarizes the prediction and control technology of the machining deformation of thin-walled parts, analysis of thin-walled parts in the processing of deformation prediction and control technology of the machining deformation with the development of Aerospace Thin-walled Parts in the design of the background. To make a comprehensive analysis of the physical properties, mechanical structure and mechanical technology etc, And put the saddle tank structure as the research model from the Aerospace Science and Industry Department， UG NX8.0 is used to create the model of thin-walled structure components, finally carries on the thorough research according to the comprehensive analysis of the results. We are able to get a dynamic process of cutting parameters on cutting force change in the process of cutting from the simulation analysis of Deform-3D finite element simulation software; The model of thin-walled structure is simplified and let it do