Opencascade教程瓶子.docVIP

Opencascade 教程瓶子 网上有中文翻译的版本。源代码已经加到MFC下面的Modeling工程下，搜索关键字MakeBottle 能找到（生成螺纹这一段是最难理解的地方，网上也没翻译全） Profile - defining support points To create the bottles profile, you first create characteristic points with their coordinates as shown below in the (XOY) plane. These points will be the supports that define the geometry of the profile. ? There are two classes to describe a 3D cartesian point from its X, Y and Z coordinates in Open CASCADE Technology:- the primitive geometric gp_Pnt class- the transient Geom_CartesianPoint class manipulated by a handleA handle is a type of smart pointer that provides automatic memory management.To choose the best class for this application, consider the following:- gp_Pnt is manipulated by value. Like all objects of its kind, it will have a limited life time.- Geom_CartesianPoint is manipulated by handle and may have multiple references and a long life time.Since all points you will define are used only to create the profiles curves, an object with a limited life time will do. Choose the gp_Pnt class.To instantiate a gp_Pnt object, just specify the X, Y, and Z coordinates of the points in the global cartesian coordinate system:gp_Pnt aPnt1(-myWidth / 2. , 0 , 0);gp_Pnt aPnt2(-myWidth / 2. , -myThickness / 4. , 0);gp_Pnt aPnt3(0 , -myThickness / 2. , 0);gp_Pnt aPnt4(myWidth / 2. , -myThickness / 4. , 0);gp_Pnt aPnt5(myWidth / 2. , 0 , 0);If you decide to use the Geom_CartesianPoint class, the syntax would be slightly different. All objects manipulated by handle must use the standard C++ operator new and are built as follows:Handle(Geom_CartesianPoint) aPnt1 = new Geom_CartesianPoint(-myWidth / 2. , 0 , 0);Once your objects are instantiated, you may need to apply methods to them. Here again, syntax is the same as in C++. For example, to get the X coordinate of a point:gp_Pnt aPnt1(0 , 0 , 0);Handle(Geom_CartesianPoint) aPnt2 = new Geom_CartesianPoint(0 , 0 , 0);Standard_Real