复印机定影温度的控制技术-控制工程专业论文.docx

CONTROL TECHNOLOGY OF COPIER MARKING TEMPERATURE ABSTRACT There are all kinds of Copiers, for example: Engineering-Copier, Multifunction-Copier, Color-Copier etc. As one of the most important part of copier, Fuser plays an important role in copier image marking system. And the fuser temperature control technology has been mastered by many copier product company in the world as the core technology of fuser. Also these companies are improving the feedback sensitivity of sensor to improve the stability of fuser temperature control technology. This article is major about developing and improving fuser temperature control technology based on copier marking technology and sensor electronic control technology integrating with sensor control theory, in order to insure copier more stable operating and promote the copier product technology. Contact thermal sensor: which used to detecting the temperature by using the film on sensor, touching the surface of Heater Roller, detecting the temperature on the edge of Heater Roller and checking the cycle no problem. The checking standard is by using the detecting temperature compared with the standard temperature to confirm whether there is any abnormal happened. Traditional fuser use contact thermal sensor, which detecting the temperature on the surface of Heater Roller by touching the surface of Heater Roller. When the temperature reaches to working status temperature, the sensor feedback to the MCU and then MCU send the next command to fuser. Because of the structure defect of the contact sensor, it is easy to be damaged at transportation, installation and in use. The damage of sensor will lead to signal fault feedback and error warning message generation and effect the working. Also the damage of sensor will cause the cost up by non-production deformation. We suppose to use non-contact sensor instead of contact sensor in fuser to detecting the surface temperature of Heater Roller and feedback the signal. And after using non-cont