基于STC单片机的智能温湿度控制器的设计与实现-计算机技术专业论文.docxVIP

The Design and Implementation Of Intelligent Temperature And Humidity Controller Based On STC Microcontroller ABSTRACT This paper is for power system, invalidation and leakage problem caused by improper temperature and humidity control component, presents to design intelligent humidity controllers,set chip technology, analog, digital electronics, circuit-aided design technology. DC ground resistance testing in groups, and the power system has been adopted as one of the necessary equipment. This paper designs a humidity controllers based on single chip technology. The system design is divided into five sub-module implements: power supply module of system, the signal processing module, the temperature and humidity acquisition module, the serial interface communication module, the human-computer interface module, the alarm circuit module and the output control module. Among them, the temperature and humidity acquisition module consists of the sensor SHT10 connected to the microcontroller, responsible for gathering the temperature and humidity of signal, then transmit into the microcontroller.These signals will compare with informations input by buttons control section. if overrun, the alarm circuit will work, and the microcontroller output control signals to start corresponding heating and dehumidification devices. The practice shows that the collocation the controller is more reasonable, more convenient to maintain, and easy to operate. Not only applicable to control of temperature and humidity ii environment, but it is also for other areas of temperature and humidity measurement. The control system design also has a higher reference value, strong commonality and adaptability. Keywords: sensor, microcontroller, anti-interference, design, realize iii 原创性声明 本人郑重声明：所呈交的学位论文，是本人在导师指导下，进行研究工作所取得的成 果。除文中已经注明引用的内容外，本学位论文的研究成果不包含任何他人创作的、已公 开发表或者没有公开发表的作品的内容。对本论文所涉及的研究工作做出贡献的其他个人 和集体，均已在文中以明确方式标明。本学位论文原创性声明的法律责任由本人承担。 学位论文作者签名： 日期： 关于学位论文版权使用授权的说明 本人完全了解河北工业大学关于收集、保存、使用学位论文的