GTAF系统的前端电子学设计与性能测试以及靶切换系统的研制-粒子物理与原子核物专业毕业论文.docxVIP

兰州大学硕士学位论文 GTAF system’s Front-end electronics’S design and performance testing and system of the target switch’S Development Abstract In order to accurately measure the neutron capture cross-section in the kcV energy range，the China Institute of Atomic Energy after the detailed design stud，proposed t O build a 4x total absorption BaF2 detector array．This detector has the high 7-ray dete ction efficiency and better energy resolution，fast response time and low neutron sensiti vi锣，which combined with time-of-flight technology can be used to measured neutron c apture cross section with high precision． The 4x barium fluoride detector consists of 42 crystals(12 pentagonal and 30 he xagonal crystals)which form a spherical shell with 10cm inner radius and 1 5cm thick ness．Crystal is packaged by the reflector,AI film and black tape．Through optical sil icone oil the crystal is coupled with the photomultiplier tubes，then form an independ ent unit y-ray detector．Each detector module has almost the same solid angle to the t ’： arget position． ． In this paper it will be described that the details of this experimental device in the automatic control target of switching devices and to enhance research and development(n，丫) nuclear real reaction section to background’S ratio，and the establishment of the detector fi-ont-end electronics and trigger the election system．The content of this paper involved the detector system’S the front-end electronics hardware and the corresponding detector which were handled by a series of relevant performance testing and discussion．Ultimately,we buiR a precision of less than or equal to lmm automatic control system to switch target,and do a series of the front-end electronic experiments for the synchronization,noise，and the sum of energy,multiplicity and reasonably analyze the experimental data,the front-end electronics— related parameters has been preliminarily got,moreover summed up the testing methods for GTAF system，this job