门叶尺寸相较大的闸门焊接技术要求.docVIP

HYPERLINK HYPERLINK HYPERLINK HYPERLINK 门叶尺寸相对较大的闸门焊接技术要求 Welding technical requirements 　　（一）钢闸门的焊接按标书技术要求及《水利水电工程钢闸门制造安装及验收规范》来确保焊接质量符合规定。 (a) welding according to the bidding documents technical requirements for steel gate and the water resources and hydropower engineering steel gate manufacture installation and acceptance norms to ensure welding quality conform to the rules. 　　（二）门叶组装完毕后，由检查人员对整体尺寸、组装质量、破口大小、组装间隙等进行严格认真的检查。如不合格必须按要求进行整改，直到合格为止，这是控制变形的方法之一。 (2) the door leaf assembly has been completed, by the inspectors to overall dimension, assembly quality and size of crevasse and assembly clearance and so on carries on the strict careful inspection. Such as unqualified rectification must be done as required, until it is qualified, it is one of the ways to control the deformation. 　　（三）闸门检查合格后，要求焊工对整体进行加固。加固长度每400mm左右必须要有一段100mm左右的加固焊（焊角高度不宜超过设计焊角或破口的1/2——1/3），以加固闸门门体的刚度，防止焊接变形的产生。加固焊要求同正式焊一致，不得有裂纹、夹渣、气孔等焊接缺陷。 (3) the gate after inspection qualified, requires a reinforcement welder on the whole. Reinforcement is around 400 mm length each must have a period of about 100 mm weld reinforcement (solder height should not exceed design welding Angle or breach to 1/2, 1/3), to reinforce the gate door stiffness of the body, prevent the formation of welding deformation. Reinforcement with formal welding welding request, can not have welding defects such as cracks, slag inclusion and porosity. 　　（四）焊材使用时，应按焊接工艺要求进行烘干后使用。焊工应随身携带保湿筒，做到随用随取。焊条在保湿筒内的存放时间不得超过4h，否则焊条应重新烘烤，重复烘烤次数不得超过两次，防止因处理产生的焊接变形。焊剂烘干需要按单位制度要求或使用说明书进行。 (4) welding materials when used, shall be in accordance with the requirements of welding technology for drying after use. Welders should carry moisturizing barrel, do along with it. Electrode in the moisture inside the cylinder storage time should not more than 4 h, otherwise the electrode should be bake again, repeat baking number must not exceed twice, prevent the welding deformation because of the processing. Flux drying need each unit