离合器课程设计绝对精品.docxVIP

佳木斯大学机械工程学院13级车辆工程专业课程设计 佳木斯大学 课程设计说明书 题目:北京牌轻型双排座载货汽车离合器的设计 学生姓名 ： 王世欣 学号 ： 专业年级 ： 车辆13级 指导教师 ： 所属学院 ： 机械工程学院 二〇一六年七月六日 佳木斯大学机械工程学院13级车辆工程专业课程设计 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT 23 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT 1 摘要 汽车离合器位于发动机和变速箱之间的飞轮壳内，用螺钉将离合器总成固定在飞轮的后平面上，离合器的输出轴就是变速箱的输入轴．在汽车行驶过程中．驾驶员可以根据需要踩下或松开离合器踏板，使发动机与变速箱暂时的分离和断开，使发动机向变速器输入动力：（1）是汽车平稳起步。（2）中断给传动系的动力，配合档位。（3）防止传动系过载。本设计主要针对某轿车设计的离合器。根据车辆使用条件和车辆参数，按着离合器系统的设计步骤和要求，主要进行以下工作；摩擦片外径的确定，离合器后备系数的确定，单位压力的确定。并进行总成设计主要为；分离装置的设计，及从动盘的设计（从动盘毂的设计），及圆柱螺旋弹簧的设计等。 关键字：单片；干式；膜片弹簧；液压操纵； PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT II PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT 1 Abstract the clutch is located in between the engine and transmission of the flywheel crust, screwed the clutch assembly fixed after the flywheel plane, clutch output shaft is gearbox input shaft. In automobile driving process. The driver stepped on the fly can according to need or loosen the clutch, make the engine and transmission temporarily separation and disconnected, make the engine to the transmission input power: (1) is car smooth start. (2) the interrupt to transmission power, cooperate a gear. (3) prevent transmission overload. This design is mainly aimed at a car designed clutch. According to the vehicle use condition and vehicle parameters, according to the clutch system design steps and requirement, mainly for the following work; Friction slices diameter determination, and clutch determination of unit is lengthened, pressure determination. And assembly design mainly for, Separation device design, and driven plate design (platen hub design), and the design of cylindrical helical spring etc. Monolithic???Dry?type; Film?spring; Hydraulic; control PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT III PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT 1 目 录 TOC \o 1-3 \h \u HYPERLINK \l _Toc26851 摘要 Ⅰ HYPERLINK \l _Toc9914 Abstract Ⅱ HYPERLINK \l _Toc22430 第1章 绪论 PAGEREF _Toc22430 1 HYPERLINK \l _Toc27693 1.1 概述 PAGER