某工业园区污水处理厂工程设计.docVIP

PAGE １５ - PAGE １５ - 某工业园区污水处理厂工程设计 摘 要：本文对规模为10000m3/d，进水COD浓度为500 mg/L，BOD浓度为180 mg/L，SS浓度为220 mg/L，氨氮浓度为35 mg/L，总氮浓度为40mg/L，总磷浓度为4mg/L，pH为6~9的某工业园区污水进行处理工程的设计。针对该项目污水有机物浓度高，氮磷浓度高的特点，本文主要采用A2/O工艺处理废水，出水COD浓度为40mg/L，BOD浓度为9mg/L，SS浓度为10 mg/L，氨氮浓度为5 mg/L，总氮浓度为12mg/L，总磷浓度为0.4mg/L，pH为6~9，满足要求。本文结合氮磷废水的特点，设计出了一套切实可行的工业园区废水处理方案，它具有出水效果好，运行成本低，管理维护简单等优点。 关键词：氮磷；工业园区废水；A2/O Sewage treatment plant in an industrial park project design Abstract: The paper makes the treatment project design based on an industrial park project wastewater, whose inflow is 10000 ton per day, and the concentration of COD , BOD, SS , NH4+-N, TN,TP, pH from inflow is 500 mg/L,180 mg/L,220 mg/L,35 mg/L,40 mg/L,4 mg/L ,6~9,respectively. Since the wastewater of the project is of high organic matter concentration, and high nitrogen and phosphorus concentrations, the paper takes A2/O as the main treatment processes, so that the concentration of COD , BOD, SS , NH4+-N, TN,TP,pH from outflow is 40 mg/L,9 mg/L,10 mg/L,5 mg/L,12 mg/L,0.4 mg/L,6~9, respectively. Combining with the characteristics of nitrogen and phosphorus wastewater, In this paper, it designs a set of practical an industrial park wastewater treatment program, it has good treatment effect, low operating costs, it is simple to manage and maintain. Keywords: Nitrogen and phosphorus; Industrial park wastewater; A2/O 目录 TOC \o 1-3 \h \u HYPERLINK \l _Toc30392 1引言 PAGEREF _Toc30392 1 HYPERLINK \l _Toc11493 1.1设计背景与意义 PAGEREF _Toc11493 1 HYPERLINK \l _Toc32755 1.1.1设计背景 PAGEREF _Toc32755 1 HYPERLINK \l _Toc9528 1.1.2设计意义 PAGEREF _Toc9528 1 HYPERLINK \l _Toc7312 1.2设计目标和思路 PAGEREF _Toc7312 1 HYPERLINK \l _Toc31173 1.2.1设计目标 PAGEREF _Toc31173 1 HYPERLINK \l _Toc28255 1.2.2设计思路 PAGEREF _Toc28255 2 HYPERLINK \l _Toc10772 2工程概况 PAGEREF _Toc10772 4 HYPERLINK \l _Toc12253 2.1设计依据 PAGEREF _Toc12253 4 HYPERLINK \l _Toc9080 2.2设计原则 PAGEREF _Toc9080 4 HYPERLINK \l _Toc27313 2.3设计水量水质与排放标准 PAGEREF _To