蜗轮蜗杆花键上促动器的设计（含全套cad图纸）.docVIP

摘要 洛阳理工学院毕业设计（论文） PAGE IV PAGE 2 蜗轮蜗杆花键促动器的设计 摘 要 本次设计主要是蜗轮蜗杆花键促动器的设计。主要是用于射电望远镜主反射面的每一小块的上下直线调整。在这次设计中通过促动器的工作场合；促动器的最大出力和已知传动速度和促动器的有效工作行程，来反推所需电机的输入功率，转矩。主要设计内容有电动机的选用，蜗轮、蜗杆轴的设计和校核，花键和滚珠丝杠的校核计算。设计的内容还包括对传动元件参数的拟定，其中包括根据一些原始数据并且结合实际条件和情况对促动器参数的拟定，通过拟定参数，对传动件的结构来进行设计，包括各传动件的定位，包括长度和直径的计算，结构支撑和扭矩，弯曲强度的计算，转矩、强度的计算，扭转变形，疲劳强度的计算，促动器上所用标准件的选择，促动器的润滑等等。通过对促动器上的零部件的校核计算，都能满足设计要求，到达了预期的目的。 本次设计的促动器的传动级数比是1:62，不仅可以用在本次设计中的工作场合，如果加以改造，还可以用到增速传动的场合。 这次设计中，通过对资源的充分利用，进一步巩固已学过的理论知识，提高综合运用所学知识发现问题、解决问题，以求把理论和实践结合一起，为以后的工作和更好的学习积累经验。同时又学习了solidworks，可以把促动器用三维立体图清晰地表达出来，同时加深了对CAD的学习。 关键词：促动器，蜗轮蜗杆，传动，转矩 THE DESIGN OF THE DRIVE FOR WORM SPLINE DRIVE ABSTRACT This design is splined worm actuator design. In this design, the actuator through workplace; effective working stroke and known maximum output speed and the actuator drive actuator, and to counter the push needed to motor input power, torque. The main design elements with an option, the worm, the worm shaft design and check, calculate the ball screw spline and check the motor. Design structure also includes the formulation of transmission elements, including some of the original data and in accordance with the actual conditions and circumstances of the actuator parameters to develop, through the development of parameters, the structure of transmission parts to the design, including the transmission parts location, including the calculation of the length and diameter to calculate structural support and torque, calculate the bending strength, torque strength, torsional deformation, fatigue strength calculations, the actuator member of the selection criteria used, the actuator lubrication, etc. . By checking calculation on the part of the actuator, can meet the design requirements, to reach the desired goal. The actuator is designed gear stage ratio is 1:62, not only can be used in this design of the workplace, if to transform, also can be used overdrive occasions. The design, by making full use of resources, to further con