单片机外文文献1.doc

单片机外文文献1 The uniform tension at a preferred value of polyester PET films in processing or rewinding is important to product quality which can be achieved by tension control Furthermore the uniform transport speed is helpful in creating uniform film tension In this article a simplified version of PET film processing systems consisting of an unwinding roll a sensor roller and a rewinding roll is considered The unwinding roll and rewinding roll are driven by a torque-controlled motor and speed-controlled motor respectively A control signal to the torque-controlled motor generated by a conventional sliding-mode controller or a fuzzy sliding-mode controller regulates the film tension Moreover the speed-controlled motor adjusts the transport speed at the winding section To improve the speed fluctuation an external proportional-plus-integral plus-derivative PID controller for the speed-controlled motor was implemented The experimental results demonstrate that fuzzy sliding-mode control gives the tension response with smaller variation than the conventional sliding-mode control does and the external PID control for speed diminishes fluctuations in speed thus leading to more uniform tension while maintaining it at the preferred value KeywordsFuzzy sliding-mode control Polyester film Tension control INTRODUCTION A thin polymer film is generally conveyed to a working zone for processing and wound for storage or final shipment on a rewinding roll by means of roll-to-roll transport mechanisms In the roll-to-roll mechanism the longitudinal behavior including tension and transport speed is important to product quality and productivity For instance when coating optical films uniform tension can avoid defects such as crossweb lines bad pasting and shrinkage even breakage In the rewinding process the film may suffer from changes in shape and from breakage or crushing of the outer layers on the inner layers when tension is too high and sagging wrinkling