电解磨削加工硬质合金涂层材料的试验研究-机械制造及其自动化专业论文.pdf.docxVIP

电解磨削加工硬质合金涂层材料的试验研究Experimental 电解磨削加工硬质合金涂层材料的试验研究 Experimental Study on Electrochemical Grinding of Cemented Carbide Coating Materials Abstract Nuclear power is one of the most important clean energy，and most of the developed countries have used nuclear power as the main source of electricity，while China’S nuclear power technology is in a stage of vigorous development．The friction pair of nuclear coolant pump is one of the key parts of nuclear power system，the requirements for its strength， hardness，wear resistance and corrosion resistance are very strict．Currently friction pair of nuclear coolant pumP is mostly using the HOVF way．Coating the tungsten carbide cemented carbide materials on the substrate surface to improve its strength and hardness，achieve the effect of wear resistance and corrosion resistance．As the working environment of the friction pair of the nuclear coolant pump is severe，the residual stress of surface after processing is strictly required．If using the traditional processing technology,the efficiency is low and the tool wear is serious．At the same time．direct contact in the process will cause damage to也e surface of friction pair which would affect the processing quality,and increase the residual stress． Because the high hardness，hilgll wear resistance and other characteristics for tungsten carbide coating materials are difficult to processing，the electrochemical grinding is adopted in this paper．Electrochemical grinding is a kind of composite processing method which combines the mechanical processing and electrochemical processing：under the action of electrochemical a soft passivation film would be formed on the surface of the coating materials，and then the grinding wheel would scrape it off the surface．This method not only improves the contact pressure between the workpiece and the tool，but also improves the surface quality．Therefore，this paper launched a series of related research，and the specific content are as follows： This paper briefly