电子模块介绍(课程版)(2017.8.3).pptxVIP

;什么是电子模块？;可以将复杂的光、声、电器、感应等物理现象，通过简单模块化的组件呈现。 电子模块为磁性吸附式接头，巧妙的利用磁石特性及卡口齿印拼接。 普及性广，孩子或成人都可以从电子模块中获取基本的电子知识，培养逻辑思维，开发创意。 ;电源;电子模块连接方式;40个基本模块玩法和功能介绍;紫色模块;一个可以充电的电源模块，为其他模块提供电源， 它可以通过标准的智慧手机充电器进行充电。 A rechargeable power module can recharge . power with a standard mobile portable charger. ;绿色模块;一、电源+输出;翠绿色的LED，连接到任意电路就被点亮。 Green LED, snap to power module or other module after power to light on LED.;o2-三色灯/RGB LED;o3-条形灯/Bargraph;o4-震动/Vibration motor;o7-蜂鸣器/Buzzer;o8-高亮LED/Bright LED;o9-直流马达S/DC motor S;o10-双LED/Double LED;o12-彩灯/Colourful lights;o13-红外反射电机/IR reflective motor;粉红色模块;二、电源+输入+输出;按下接通，松手断开，代表电路的两个状态：“0”和“1”。 Press and hold or release to make things happen.;旋转它可以调节信号的电位，也就是调节信号大小。 Rotate the dimmer to adjust signal. ;通过触摸来激活的模块，你给它小小的挤压力来激活它，压力越大变化越大。 It’s a touch activated module. Give its pad a little squeeze to activate it. The more pressure you apply, the more power it sends out. ;脉冲就像是脉搏一样的跳动，你可以通过螺丝刀调节跳动的快慢，也就是调节频率。 The pulse is like an electronic heartbeat.You can adjust the speed of the pulses faster or slower by using a screwdriver. ;拨动拨杆可实现电路的通断，电路在“0”和“1”之间切换。 The toggle is an on/off switch.;对光线敏感，两种模式：“亮”和“暗”， 在亮模式下，光线越亮，输出信号越强。 在暗模式下，光线越暗，输出信号越强。 可以通过调节电位器来调节模块对光强的灵敏度。 The light sensor measures how much light shines on it. It has two modes:“light” and“dark”. In“light” mode, the more light shines on the sensor, the higher the signal it sends out. In dark mode”, it is opposite of the“light mode”. ;滚轮推入和释放代表接通和断开两个状态，拨动开关可以翻转状态。 It has a little lever with a wheel, and activates when something moves past it.You can also flip the mode switch to make it turn off when the lever is pushed in.;可以自锁的开关，按下接通，再按下断开。 It has a self-locking on/off button. It stays in the current locking stage or releasing stage until it is pressed again. ;对声音敏感，可根据接收到的声音控制拼接在其后端的输出模块，通过调节模块上的电位器可以调节其灵敏度。 The sound trigger module reacts to any sound source when it gets over a certain level. You can adjust the sensitivity of the module by using a screwdriver. ;对输入信号进行延时后输出，通过调