基于USB接口的PPT远程控制系统的设计.docVIP

大连海事大学 ┊┊┊┊┊┊┊装 ┊┊┊┊┊┊┊装┊┊┊┊┊┊┊订┊┊┊┊┊┊┊线┊┊┊┊┊┊┊ 　 　　 二○一四年六月 基于USB接口的PPT远程控制系统的设计 专业班级： 通信工程1班 姓 名： 胡宇翔 指导教师： 李作洲 信息科学技术学院 摘 要 PPT遥控器是一款用USB来控制计算机播放PPT的小应用。在日常生活中适应于教师和HYPERLINK /view/315045.htm管理员们演示PPT，帮助他们摆脱线绳的束绊。 本论文设计了一个基于51单片机的外接USB接口芯片PDIUSBD12的幻灯片无线遥控器。无线通信产品一直朝着低成本、低消耗功率、小体积等趋势向前发展。本设计由无线发射手柄部分和无线接收部分构成。在设计中各方面都尽可能的考虑了用户使用的方便简捷和携带方便，采用了大量方便用户使用的设计结构，如：使用射频信号来传播遥控信号，减少使用方向性的影响；系统采用最近流行的USB接口设计，大大简化了设备的安装；设计了合理的状态显示指示灯，方便用户对设备工作状态的了解；等等。作为一款基于USB接口的微型设备，低功耗和低成本是设计的两大要点。本论文在设计的每一个模块中都认真地研究和讨论了这些问题，最终使整个系统的功耗和成本控制在较低的水平之上。 关键词：PPT遥控器；51单片机；USB接口 Abstract The PPT controller, considering in this thesis, is an operating handle used to control PPT through USB interface. Users such as teachers and administrators can send operate instruction by wireless control and free from keyboard operating. According to the reasons mentioned above, we design a controller, called remote controller, based on 51 single chip microcomputer and external USB interface chip PDIUSBD12. Wireless communication products take advantages on low cost, low power consumption and small volume, so they embody the development trend. The system consists of a wireless transmitting handle part and a wireless receiving part. In the design of all aspects, the convenience and portability are considered as far as possible, such as designing the handle structure; using radio-frequency signal to spread the remote control instructions; reducing the impact of the use of directional; using the popular USB interface, which is greatly simplify the equipment installation; designing a reasonable state indicator lamp, which is convenient for user to understand the status of equipment. As a micro device based on USB interface, low-power-consumption and low-cost are two essentials of the design. In this thesis, each module design is studied and discussed on these questions, in order to reduce power consumption and cost to a lower level. Keywords: PPT remote control, 51 single chip microcomputer,USB