沟槽植筋新旧混凝土c30结合面抗剪性能试验研究桥梁与隧道工程专业论文.docxVIP

广东工业大学硕士学位论文ABSTRACT 广东工业大学硕士学位论文 ABSTRACT The augmented section method and the additional prestressing method have become common way of strengthening concrete structure．The shear resistance of the new and existing concrete interface is the key for the of the two methods．The shear resistance of the new and existing concrete interface can be improved by cutting groove and implanting rebar the interface．But it iS lack of research at home and abroad．and there’S no relevant design specification in country,SO it is significant to study the shear behavior of groove interface with rebar between new and existing concrete． Interface processing，groove size and steel ratio set test parameters in this paper． 1 8 specimens with different parameters made and tested．The influence of different test parameters shear behavior of the new and existing concrete interface is studied by cracking load，residual load，ultimate strength，slippage，transverse displacement and failure mode of the specimens．Achievements have been made as followings． (1)In this paper，the reasons for the weakness of the new and existing concrete interface are analyzed，the influence factors on the bonding property of the new and existing concrete interface summarized．Based on the bonding model，the bonding mechanism of the new and existing concrete interface is analyzed under the condition of both implanting rebar and without implanting rebar． (2)Test results show that the cracking load of the new and existing concrete interface be improved by cutting groove，increasing the width of the groove and increasing the ratio of implanting rebar the new and existing concrete interface．The residual load of the new and existing concrete with rebar increased with increasing the steel ratio．cutting groove the new and existing concrete interface with rebar also improve the residual load while the width of the groove has less influence it． (3)According to the shear load—vertical slip curves and the shear load·horizontal slip of the n