twin乘客电梯检验研究机械工程专业论文.docxVIP

TWIN乘客电梯检验研究Abstract TWIN乘客电梯检验研究 Abstract Usually single lift running single shaft and each elevator run independently． Even in a small number of cases，the elevator alSO in accclrdance with the operation of the program is intended step by step，making of the lift efficiency is low，people often need to wait for long time to take the elevator．If the two elevator capsules are arranged by running in hatchway，SO can not only improve the efficiency of the use of the elevator hatchway． Saving the occupied area，and greatly improve the efficiency of the use of the elevator． Based this idea，the TWIN elevator system was produced． The twin system and its characteristics is to have two elevator cal along with guide rail， but two car power system is respectively，which are equipped with respective traction machine and traction system and weight system to ensure them in with shaft can respectively towards different floors．Compared with the仃aditional elevator running in their respective Iift in orbit． the capacity of TWIN be increased by 40％and Can reduce the volume of a building elevator hatchway． Due to the two in the same well and with set of guide rail operation．Therefore，in order to reduce the security risks，improve the safety of the elevator，twin passenger elevator set anti collision device(collision prevention device for CPD，the lower part of the ascending Car safety tongs，layers of door layers and off door lock detection device． For these safety devices，this article，referring to the current inspection specification the TSG700 1--2009((Regulation for Lift Supervisory Inspection and Periodical Inspection·-Traction and Positive Drive Lift))was studied，this paper put forward some new test methods，including the anti collision device of CPD，space at the top and bottom of the space and layer door closed test research． Twin system uses the destination floor control system(destination selection contr01)，SO to realize the mutual cooperation with elevator operation，but also avoid the c