标准机柜结构设计-规范.docVIP

bd `` bd `` Q/UTS UT斯达康通讯有限公司企业标准 Q_UTSB_006A 19″标准机柜结构设计规范 The mechanical criterion of 19 inch normal cabinets designing 2005-11-15 发布 UT斯达康通讯有限公司 发布 bd `` bd `` Revision History Revision # Author Reviewed By Description Of Change Issued By/Date A.0 Xu jianhua New standard document UTStarcom Proprietary Not for use or disclosure outside UTStarcom, Inc. or any of its subsidiaries Except under prior written agreement. Intended Audience: H/W Group, Quality Assurance Group Internal Auditors. This document is controlled electronically and any hard copy should be considered uncontrolled. This document is owned by HZ of Mechanical Development Process Team Chairperson.  前 言 本标准制订的目的，主要是为了适应公司日益全球化发展的需要，也是为了增强公司机柜可互换性、提高公司机柜设计效率和质量、降低公司机柜研发和生产成本的需要。 本标准主要以IEC标准为主，参照了ETSI、NEBS标准对机柜性能部分的要求及NEBS标准对机柜工程安装的要求。 标准起草：徐建华  目 次 TOC \o 1-2 \h \z HYPERLINK \l _Toc118724530 1 范围 PAGEREF _Toc118724530 \h 1 HYPERLINK \l _Toc118724531 2 引用标准 PAGEREF _Toc118724531 \h 1 HYPERLINK \l _Toc118724532 3 术语定义 PAGEREF _Toc118724532 \h 2 HYPERLINK \l _Toc118724533 3.1 设备实体(equipment practice) PAGEREF _Toc118724533 \h 2 HYPERLINK \l _Toc118724534 3.2 机柜(cabinet) PAGEREF _Toc118724534 \h 2 HYPERLINK \l _Toc118724535 3.3 机架(rack) PAGEREF _Toc118724535 \h 2 HYPERLINK \l _Toc118724536 3.4 插箱(subrack) PAGEREF _Toc118724536 \h 2 HYPERLINK \l _Toc118724537 3.5 机箱(chassis) PAGEREF _Toc118724537 \h 2 HYPERLINK \l _Toc118724538 3.6 插件(plug-in unit/model) PAGEREF _Toc118724538 \h 2 HYPERLINK \l _Toc118724539 3.7 机柜高度 (cabinet height) PAGEREF _Toc118724539 \h 2 HYPERLINK \l _Toc118724540 3.8 机柜宽度 (cabinet width) PAGEREF _Toc118724540 \h 3 HYPERLINK \l _Toc118724541 3.9 机柜深度 (cabinet depth) PAGEREF _Toc118724541 \h 3