热处理工艺对30Cr3MoV低合金钢力学性能影响.PDFVIP

y m m i u t y 本文引用格式：王辉，徐锟 . 热处理工艺对30Cr3M oV 低合金钢力学性能影响 [J].新型工业化，2017, ( 1 0 )： 43-48. D O I ：10.19335/ki.2095-6649.2017.10.007 热处理工艺对30Cr3M oV 低合金钢力学性能 影响 王 辉 ，徐锟 ( 宝钢轧辊科技有限责任公司，江 苏 常 州 213019) 摘要：对新型低合金钢 30Cr3MoV在不同热处理工艺条件下硬度、室温力学性能及高温力学性能等变化规律进行 研究。并与传统芯棒用H 13 热作模具钢的高温力学性能进行对比研究。完成了小炉试验成果向中试产品的转化。结果表明： 随回火温度升高，材料的硬度不断下降；同一回火温度条件下，淬火温度越高，硬度越高。在 1020^ 左右淬火硬度达到 最大值，在 910 〜9 3 0 t 进行淬火，可获得晶粒度和强韧性的良好匹配。30Cr3MoV调质组织为回火索氏体。在 6 0 0 t 进 行试验，30Cr3MoV高温强度优于H 1 3 ; 在 7 0 0 t 进行试验，30Cr3MoV高温强度低于H13 。提高室温硬度，可以提高 材料的高温强度。通过热处理，30Cr3MoV钢的性能能够满足芯棒用钢在高温下服役的要求。 关键词：30C r3M oV ;热处理；H 1 3 ; 力学性能；芯棒 Effect of Heat Treatment Process on Mechanics Properties of Low-alloy 30Cr3MoV Steel W A N G H u i , X U Kun (Baosteel roll technology Co., Ltd., Changzhou 213019, China) Abstract: Effect of hardness and room temperature mechanical properties and high temperature mechanical properties of 30Cr3MoV low-alloy steel was researched by different heat treatment process and compared with the traditional mandrel used H13 hot die steel. The pilot product was completed by the transformation of small furnace test results. The results show that the hardness was falling with the tempering temperature increase. In same tempering temperature conditions, the higher of quenching temperature, the higher of the hardness. The quenching hardness reached the peak value at the temperature of 1020 ^ . Quenching at 910 ^ to 930 ^ can obtain good matching between grain size and strength toughness. 30Cr3MoV can acquire tempered sorbite after quenched and tempered process. At 600 ^ test, 30Cr3MoV steel high temperature strength was better than that of H13; While at 700 ^ test, the high temperature strength less than H13. The high temperature strength of materials can be