虚拟机不能桥接的问题解决.docVIP

虚拟机不能桥接的问题解决 Virtual machines cannot be solved by bridge problems The 2011-08-05 land Meeting a virtual machine today can，t bridge the problem It turned out that there were fewer local connections: VMware Bridge Protocol This is found in the connect!on properties of the local network card after nonnal installation. Install the following method: Open the physical network card local to the - property Install - (selected service) - from disk installation - - X: \ Program Files \ VMware \ VMware Workstation directory to select netbriclge? Inf X represents the installation of your vmware software installation. Double-click VMware Bridge Protocl to write 0 when the installation is complete? Then restart the computer. Bridge: Connected directly to the physical network can be used. Enter the text screen Find the/etc/inittab file, and then open it and find the line: Id: 5: initdefault? Change 5 to 3 to save and restart If you go to the graphical interface, you change it to 3 The chkconfig command simply checks and sets the automatic start of the service, and does not reflect the current state of the service? The service iptables status can see the current state of the iptables service The iptables L? The return value of the above command does not work if it shows no firewall rules; Conversely, firewalls are at work? Enter setup to select a firewall to set up df Function: check the disk space footprint of the file system? You can use this command to get how much space your hard disk is occupied and how much space is left? Initl should be single-user mode The different runlevel definitions are as follows (you can refer to the /etc/inittab in Red Hat Linux) 0 - stop (you can，t set initdefault to 0) 1 - single-user mode 2 - multiple users, no NFS 3 - full user mode (standard runlevel) 4 一 no use 5 - Xll (xwindow) 6 - restart (don，t set initdefault to 6) These levels are specified in the /etc/inittab file? This file is the main file that the init program looks for, the most Th