基于Cordic计算单元的极坐标发射机电路-集成电路工程专业论文.docxVIP

Abstract Abstract Abstract The continuous development of information technology has pushed the wireless electronic equipment towards lower power, low cost and better-performed. The best way to meet the requirement of modern advanced wireless communication is utilizing hardware circuits based on CMOS IC(Integrated Circuit) technology. Among the circuit blocks, transmitter always plays a significant role in many wireless applications.The research on high-efficient and low power transmitter circuit is always a hot issue in both industrial design and academic research, and draws a lot interest from worldwide. This thesis mainly focuses on an approach to improve the performance of transmitter at its circuit structure and topology level. At the beginning,the basic concepts and structure of quadrature modulation based transmitter were introduced. The quadrature transmitter system separates the series baseband signal stream into two parallel sub-streams,and it employs a couple of LO(Local Oscillator) signal with a fixed phase difference of 90 degree to realize up-conversion. The signal paths of this structure can be divided into I(in-phase) path and Q(quadrature-phase) path since the quadrature LO signals on each path. The main drawback of quadrature system is the mismatch between I and Q path, this would cause serious harm to total performance.To improve this, a new transmitter structure based on polar modulation is proposed in this thesis. Unlike quadrature structure, polar modulation converts parallel signal to its relative polar formation,by using two new variables amplitude A(t) and phase Φ(t), through amplitude modulation and phase modulation separately, the combined signal at output is equivalent to traditional modulation system.The proposed structure mainly consists of the signal form conversion block, phase path, envelope path. Based on Cordic computer, signal form conversion block is built in Modelsim platform, it separates the desired signal from initial I and Q.