实验四 广域网PP(下两台路由器).pptVIP

1 实验四 PPP ISSUE 2.0 实验报告 1. 实验内容：PPP协议的验证 2. 实验目的：掌握PPP协议的PAP验证机制 3. 实验环境 H3C S系列路由器2台，Comware操作系统，PC机2台，标准网线若干 4. 实验步骤 PPP的PAP单向验证 1. 画出网络拓扑，并按拓扑图连接网络，其中RTA是验证方，RTB是被验证方。 PPP的PAP单向验证 2. 配置路由器（二台中的上面一台，注意不要选错）串口。输入下列命令： [H3C]sysname RTA [RTA]interface Serial 0/0 [RTA-Serial0/0]ip address 192.0.0.1 24 PPP的PAP单向验证 3. 配置路由器（二台中的下面一台，注意不要选错）串口。输入下列命令： [H3C]sysname RTB [RTB] Interface serial 1/0 [RTB-Serial1/0]ip address 192.0.0.2 24 4. 在RTA上测试与RTB串口的连通性，此时应连通。输入下列命令： [RTA-Serial0/0]ping 192.0.0.2 PING 192.0.0.2: 56 data bytes, press CTRL_C to break Reply from 192.0.0.2: bytes=56 Sequence=1 ttl=255 time=25 ms Reply from 192.0.0.2: bytes=56 Sequence=2 ttl=255 time=25 ms Reply from 192.0.0.2: bytes=56 Sequence=3 ttl=255 time=25 ms Reply from 192.0.0.2: bytes=56 Sequence=4 ttl=255 time=25 ms Reply from 192.0.0.2: bytes=56 Sequence=5 ttl=255 time=25 ms --- 192.0.0.2 ping statistics --- 5 packet(s) transmitted 5 packet(s) received 0.00% packet loss round-trip min/avg/max = 25/25/25 ms 5.显示RTA串口的状态信息（RTB串口的显示类似），记下红色的文字，说明其含义。 [RTA-Serial0/0]display interface Serial 0/0 Serial0/0 current state: UP Line protocol current state: UP Description: Serial0/0 Interface The Maximum Transmit Unit is 1500, Hold timer is 10(sec) Internet Address is 192.0.0.1/24 Primary Link layer protocol is PPP LCP opened, IPCP opened Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0 Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0 Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0 Physical layer is synchronous, Virtual baudrate is 64000 bps Interface is DTE, Cable type is V35, Clock mode is DTECLK1 Last clearing of counters: Never Last 300 seconds input rate 3.99 bytes/sec, 31 bits/sec, 0.22 packets/sec Last 300 seconds output rate 4.00 bytes/sec, 32 bits/sec, 0.22 packets/sec Input: 340 packets, 4474 bytes 0 broadcasts, 0 multicasts 0 errors, 0 runts, 0 giants 0 CRC,