采矿工程毕业设计（论文）-华亭煤业华亭一矿开采设计.doc

全套图纸加扣?3012250582 PAGE 53 全套图纸加扣?3012250582 设计题目：华亭煤业华亭一矿开采设计 专 业：采矿工程 本 科 生： （签名） 指导老师： （签名） 摘 要 本设计以华亭煤矿5号煤层为开采煤层。5#煤层地质条件较为简单，煤层倾角6-8度，平均煤厚39.2m，矿井设计资源量445Mt，设计可采储量306.12Mt，设计生产能力3.4Mt/a，服务年限89a。 本矿井采用立井开拓，设置主立井，副立井，回风立井。盘区划分，条带式开采，采用倾斜长壁分层综采低位放顶煤法。本设计是以华亭煤矿的地质资料为基础，在贠老师的精心指导下，严格按《煤矿安全规程》、《煤矿设计规范》要求设计。本设计以理论联系实际，重点针对该矿井的概述及矿井地质、井田境界及储量、井型服务年限、井田开拓、采煤方法、井下运输、提升方式、通风与安全、排水等方面展开的，对同类矿山开采具有一定指导意义。 关键词：采煤方法、立井开拓、综采放顶煤、分层开采、运输、通风、环境保护 Subject ： The mining design of Huating one coal group in Huating coal mine Specialty : Mining Engineer Name : Li zenghui （Signature）__________ Instructor ：Yun dongfeng （Signature）__________ Abstract The paper is designed on the basis of 5# coal seam on Huating coal mine.The geological condition of 5#coal seam is simple and its dip angle coal is 6 to 8 degree. Besides the average thickness of 5#coal seam is nearly 39.2m. The designed mine resource is 445 Mt and recoverable reserves is 306.12 Mt.The coal seam of design production capacity is 3.4Mt/a and the length of service This mine uses shaft development way, sets the main shaft, auxiliary shaft and air shaft. Disk partition, strip mining, using full-mechanized caving mining method. The design is based on Huating coal mine geological data, the instructor under the careful guidance by teacher Yun, in strict accordance with the coal mine safety regulations, standard requirements of the design of coal mine design. This design to link theory with practice, focus on the mine survey and mine geology, Ida state and reserves, well service life, Ida forge, mining method, underground transport, lifting, safety and ventilation, drainage and other aspects, for similar mining has certain guiding significance. Key words: vertical shaft development、full-mechanized caving mining、layer mining、transportation、ventilation、environmental protection