课件：呼吸麻醉教学资料 servo-i呼吸机.ppt

Plug’n’Play Module 145 Battery indicator OH 8:020 25% 50% 75% 100% Remaining capacity: 145 Operating time: 30 min Charging time: 3 h Battery charging Low charge Normal charge Trickle charge Volt 10 12 1 2 3 4 Batteries If more than 1 battery is inserted, each battery is charged for 10 minutes before switching to next. Battery discharging Volt 12 1 2 3 4 Batteries Diod voltage Discharging always starts with the battery with the highest voltage, then the second highest etc. Patient unit flexibility OH 8:008 PC 1777 Panel SM 2-3 Patient unit - Internal layout SM 2-5 PC 1781 Insp. Pressure transducer PC 1784 Exp. channel PC 1771 Control PC 1772 Monitoring PC 1775 Plug’n’Play AC/DC Converter PC 1781 Exp. pressure transducer Expiratory Valve Coil PC 1778 Connections DC/DC converter Internal fan Mains supply inlet PC 1770 Main Back-plane SM 2-5 PC 1770 Main back-plane PC 1780 Adaptor board Options - Servo Ultra Nebulizer OH 7:024 Servo-i Mobile Cart with Compressor Mini OH 8:010 Gas cylinder application OH 8:012 Servo-i holder OH 8:013 PC 1781 - Pressure Transducer Pressure transducer Pre-amplifier Two similar PC-boards in the vent one for the inspiratory pressure  and one for expiratory pressure Interchangeable boards Memory prom on the board PC 1784 - Expiratory Channel Mother board for pressure transducers Safety valve control PEEP-valve control Exp flowmeter electronics Siemens 167-processor ID-prom PC 1771 - Control Control processor for inspiratory and expiratory valve Nebulizer electronics Motorola 826 processor Battery back-up Flash Memory ID-prom  PC 1772 - Monitoring Control processor for  monitoring and alarm handling. Host for CI-interface Back-up buzzer Barometer Motorola 826 processor Battery back-up Flash Memory ID-prom PC 1775 - Plug-and-Play Back-plane Identifies mounted PP-modules. Controls battery charging / discharging. Primary version contain socket  based micro processor including prom.