servo-i呼吸机使用说明.pptVIP

* The previous exhalation always sets the stage for the following inhalation. A high expiratory resistance will impose a load which will constitute an internal trigger threshold. A weak effort in this situation may not reach the trigger threshold set on the ventilator. The Time Constant Controller Valve? of the Servo-i will guarantee that there will be a very low resistance to the exhalation. This in turn will favour triggering, as hyperinflation is minimized, resulting in a situation where a consistent patient effort will be consistently rewarded. The superior speed in sensing and controlling will likewise give immediate unloading during laboured breathing. Depending on the situation, the work performed by the patient can be tailored by the degree of support and very important, by adapting the rise time to patient conditions. A very short rise time may deliver a semi controlled breath while with a tailored rise time the Servo-i will give superior response to patient demand. * Backup Ventilation Backup ventilation is available in Pressure Support/CPAP. If the Apnea alarm limit is reached the ventilator will automatically switch to backup mode, Pressure Controlled ventilation. During backup ventilation, default settings are used for I:E ratio, Respiratory rate, and Inspiratory rise time. The apnea alarm can be set at increments of 1 second (15-45). The backup pressure level has a range of 5-120 cmH2O and default setting 20 cmH2O. * * 此时只有两根小儿呼吸管路，所以顺应性补偿0.19， 当接入四根管路时， * 可能原因 呼吸回路泄漏 呼吸机硬件故障 报警设置界限不当 处理方法 调整报警界限设置 检查患者及呼吸回路 执行使用前检查 PEEP低报警 可能原因 患者呼吸频率异常 触发灵敏度设置不当 报警设置界限不当 处理方法 调整报警界限设置 检查患者情况 检查触发灵敏度设置 呼吸频率报警 基本操作 启动呼吸机 开机自检 将蓝色测试管连接在吸入端和 呼出段之间 开机自检 断开呼吸机的主电源 开机自检 连接好外部管路，用力堵住Y 形口 顺应性补偿 待机和运行模式 * * * * The previous exhalation always sets the stage for the following inhalation. A high expiratory resistance will impose a load which will constitute an internal trigger threshold. A weak effort in this situation may not reach the