太阳能热水器使用中译英修改.docVIP

PAGE / NUMPAGES Kerste 太阳能 Solar Energy 太阳能热水器Solar Water Heater Product Structure 1. Water tank shell 2. Thermal barrier 3. Inner tank 4. Upper exhaust cap 5. Seal ring 6. Outer tank end cover 7. Scraper seal 8. Multifunctional upgraded reserved hole (Mg bar mounting hole) 9. Vacuum heat collector 10. Water inlet and outlet 11. Tube support 12. Holder 13. Tank support Operation Instruction 1. The product shall be handled with care during transportation and installation. 2. It’s forbidden to block up the air exhaust opening! Tee shall be mounted with the upper interface for air exhaust and lower interface for overflow, it’s not allowed to directly connect to any other tube! Otherwise, the water tank may be swollen or shrunk due to poor air exhaust. 3. After connecting the tank support and lacing wire with front and back holder, the water tank shall be placed on holder, pay attention that evacuated tube hole of water tank shall be directed at holder bottom support box, and ABS plastic holder shall be mounted into bottom support box hole, then put the four screws at the bottom of tank，don’t fasten them at first, mount the decorative rubber ring with water onto evacuated tube, soapsuds shall be coated at the seal outside of evacuated tube as lubricant, and the evacuated tube with water shall be inserted into water tank hole (twist it). After the evacuated tube if fully inserted, the water tank angle shall be adjusted a little. Then fasten the screws firmly at the bottom of tank and insert the evacuated tube insert back to the relevant ABS holder (twist it). 4. When connecting water feed tube and drain tube, it’s best to choose special composited tube or cross-linked tube so as to reduce watermark and heat loss, the heat of tube shall be preserved with heat insulating material, which can be used together with cable during charged heating. Fix the water feed tube and drain tube on holder or