固态继电器及其组合模块电磁干扰分析技术的研究电气工程专业论文.docxVIP

哈尔滨工业大学工学硕士学位论文 哈尔滨工业大学工学硕士学位论文 II II Abstract With the rapid advancements in modern electronic technology, the trend in electronic industry is moving toward higher operating frequencies and speed, more complex designs, sharper rise times, shrinking device sizes and lower power consumption, which increases the radiated electromagnetic interference (EMI) problems of electronic systems dramatically. So radiated EMI is one of the key factors which decide the performance of electrical systems. Solid state relay (SSR) and its combined module are widely used in industrial, military and aerospace fields. The severe EMI generated when SSR and its combined module work would fail the system. And the electromagnetic environment in which the SSR and its combined module work is so complicated and severe that it could cause the misoperation of SSR. So research on radiated EMI of SSR and combined module is of both theoretical and practical value to improve the stability and reliability of industrial, military and aerospace systems. This paper analyzed the electromagnetic radiation (EMR) of SSR by using the Ansoft Designer, built the emission model of SSR based on method of moments (MoM), calculated the electromagnetic radiation levels, obtained the distribution map of near field, analyzed the relationship between the radiation level and the layout and wiring modes of PCB, and depressed the emission levels by optimizing the cabling mode and circuit area. This paper analyzed electromagnetic susceptibility (EMS) of SSR by using the Ansoft HFSS, established the susceptibility model of SSR based on finite element method (FEM), calculated the induced voltages on tracks of circuit when incident wave is imposed, researched the affect on the internal circuit from the induced voltage, obtained the key factor which decides the EMS of SSR, reduced the EMS of SSR by optimizing the main structure such as the cable and the hole, and the rules of optimization are pre