8.PoE介绍和攻击（签名）.pdfVIP

局域网安全2008 主 教 教 PoE介绍和攻击 明 任 现 作者:现任明教教主 Email:cisco@ Security CCIE#13778 Introduction to PoE 主 1.两个标准 教 a.Cisco prestandard 教 b.IEEE 802.3af 明 2.主要作用 任 The main motivation behind PoE is to simplify the cabling of Ethernet devices. If the device’s power consumption is less than 15.4 Watts (W), the Ethernet switch 现 can provide the electrical power; there’s no need for the device to have an additional power-supply cord and power supply. 3.使用PoE的设备 a.IP telephony b.AP c.Video surveillance 等等 How PoE Works 主 Both Cisco prestandard and IEEE 802.3af PoE work in the same way: 教 • Detection mechanism. 检查连接的设备是否需要电源。 教 • Powering mechanism. 传输电源到连接的设备上去。 明 任 现 Within the Ethernet switch, the power supplying equipment (PSE), supplies power to a powered device (PD) that’s locatedwithin the powered end station (PES). Detection Mechanism Cisco prestandard 主 Cisco prestandard. Injects an alternating current (AC) signal on one pair of the CAT5 cable and checks whether the PES returned this 教 current on another pair （注入一个交流信号在CAT5的一对电缆里边，然 教 后检查是否PES能够从两外一对电缆里边把这个信号反馈回来） 注意：中间不能够有Hub 明 任 现 Detection Mechanism IEEE802.3af