斜温层单体蓄热罐性能改进的模拟研究-中国电机工程学报.PDF

第39 卷 第3 期 中 国 电 机 工 程 学 报 Vol.39 No.3 Feb. 5, 2019 2019 年2 月5 日 Proceedings of the CSEE ©2019 Chin.Soc.for Elec.Eng. 773 DOI ：10.13334/j.0258-8013.pcsee.180927 文章编号：0258-8013 (2019) 03-0773-09 中图分类号：TK 124 斜温层单体蓄热罐性能改进的模拟研究 戈志华，张飞宇，张尤俊 ( 电站设备状态监测与控制教育部重点实验室(华北电力大学) ，北京市 昌平区 102206) Simulation on Performance Improvement of Single Thermocline Energy Storage Tank GE Zhihua, ZHANG Feiyu, ZHANG Youjun (Key Laboratory of Condition Monitoring and Control for Power Plant Equipment, Ministry of Education (North China Electric Power University), Changping District, Beijing 102206, China) ABSTRACT: The analysis model of different working 罐比矮胖型的放热性能强，且斜温层在靠近上布水器附近 condition group was established with a cylindrical tank in 时，扰动会加强。研究结果可为热电联产机组应用大型蓄热 vehicles with a horizontal hole distribution of bilateral, and the 水罐，开展供热灵活性调峰改造提供工程指导。 fluid simulation was carried out; and the simulation results 关键词：布水器；水平双侧开孔；Ansys Fluent ；斜温层； were analyzed by using the thickness of the inclined 无量纲㶲损 temperature layer and the number of non dimensional exergy loss. The influence of the number of openings and the diameter 0 引言 of the opener, the diameter of the water distributor and the ratio 我国“三北”地区，燃煤热电联产机组占比高， of height to diameter of the tank on the heat release 供热季热电联产机组通常以热定电方式运行[1]，当 performance of the regenerator was studied. The results show: the greater the number of openings, the larger the opening 热负荷需求大时，供热机组上网电量大，为满足供 diameter, the larger the hole diamet