热处理工艺对活塞杆硬度的影响.PDF

下半月出版 Material Heat Treatment 材料热处理技术 热处理工艺对活塞杆硬度的影响 1 2 1 2 陈志林 , 卢庆华 , 顾俊杰 , 秦优琼 (1. 上海齐耀动力技术有限公司, 上海 201203; 2. 上海工程技术大学 材料工程学院, 上海 201620) 摘 要 通过 不同热处理状态下的42CrMo 合金结构钢的硬度测定和显微组织观察 分析了热处理工艺 合金 硬度的影响遥 结果表明 细杆高频淬火后近表面硬度为689.4 HV 1.0 淬硬层平均硬度为434.6 HV0.1 曰回火后淬硬层平 均硬度略有降低曰 底座高频淬火后淬硬层厚度为 1.16 mm 硬度为459.4 HV0.1 表面淬火+ 回火后淬硬层的厚度为 0.96 mm 硬度为464.7 HV0.1遥 两种热处理工艺均能保证细杆和底座的淬硬层与基体之间形成缓降式硬度梯度过渡遥 关键词 活塞杆曰表面处理曰淬硬层曰硬度梯度 中图分类号 TG 156.3 文献标识码 A 文章编号 Effects of Heat Treatments on Hardness of Piston Rod 1 2 1 2 CHEN Zhilin , LU Qinghua , GU Jiejun , QIN Youqiong ( 1. Shanghai Mic ro Powers Ltd., Shanghai 20 1203, China; 2. Shanghai Unive rs ity of Enginee ring Science , Shanghai 201620, China) Abstract 院The effects of different heat treatments on the hardness of alloy constructional steel 42CrMo were studied through hardness and microstructure researches. The results show that the near surface hardness of slim bar with high-frequency hardening is 689.4 HV 1.0. The average value of hardening zone is 434.6 HV0.1, which decreases slightly after tempering. The hardening zone depth of the base is 1.16 mm and the average hardness value is 459.4 HV0.1 with high-frequency hardening. After tempering, the hardening zone depth is 0.96 mm and the hardness is 464.7 HV0.1. The gradual ha