柔体(含刚柔混合)动力学分析-练习.pptVIP

Summary (cont’d) After selecting the “Connections” branch and click on the “Worksheet” tab, the Joint DOF Checker will list how many free DOF are present. While this model may be reported as “overconstrained,” it actually solves fine, so this topic was not covered. In general, the Joint DOF Checker should be used as a simple means of checking for overconstraint. For the present model, the fixed joint “Fixed - conrod-brg:1 To conrod-brg:2” causes the overconstraint because it is redundant. If it is suppressed, the Joint DOF Checker reports free DOF. However, including the redundant joint does not produce adverse effects (it is not a real overconstraint since it is fixed to two other bodies that are fixed to each other). * 11.0 New Features 2/23/2007 ? 2007 ANSYS, Inc. All rights reserved. 11.0 New Features ANSYS, Inc. Proprietary 柔体动力学分析_练习 Overview In this example, a Flexible Dynamic Analysis will be performed on a part of an engine assembly: Both Rigid Dynamic and Flexible Dynamic Analyses will be solved and compared Joint definition and loading will be covered For the Flexible Dynamic Analysis, stresses in the connecting rod are of interest, so only that part will be flexible Assembly is from an Autodesk Inventor sample model Steps necessary to performthis workshop will be shownwith bullet points Assembly shown here is from an Autodesk Inventor sample model Open Simulation Database Open “Engine Assembly Example.wbdb” From the Project page, open the “Model” Simulation Database The assembly has already been imported. Note that the assembly is initially misaligned. This will be corrected during the course of the workshop. Example the parts in the “Geometry” branch. Note that all the parts are set to be rigid for now, and some parts that are unnecessary have been supressed. Overview of Joints to be Defined For this model, 9 Body-to-Body Joints will be defined (shown on bottom left) to provide constraints on movement between the 9 bodies 2 Body-to-Ground Jo